
[Federal Register Volume 78, Number 64 (Wednesday, April 3, 2013)]
[Notices]
[Pages 20172-20174]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 2013-07762]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration

[Docket Number NHTSA-2013-0044]


Reports, Forms, and Recordkeeping Requirements

AGENCY: National Highway Traffic Safety Administration (NHTSA), U.S. 
Department of Transportation (DOT).

ACTION: Request for public comment on extension of a currently approved 
collection of information.

-----------------------------------------------------------------------

SUMMARY: Before a Federal agency can collect certain information from 
the public, it must receive approval from the Office of Management and 
Budget (OMB). Under procedures established by the Paperwork Reduction 
Act of 1995, before seeking OMB approval, Federal agencies must solicit 
public comment on proposed collections of information, including 
extensions and reinstatement of previously approved collections. This 
document describes an existing collection of information for an 
existing regulation for the aftermarket modification of vehicles to 
accommodate people with disabilities, for which NHTSA intends to seek 
renewed OMB approval.

DATES: Comments must be received on or before June 3, 2013.

ADDRESSES: Comments must refer to the docket number cited at the 
beginning of this notice, and may be submitted by any of the following 
methods:
     Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the online instructions for submitting 
comments.
     Mail: Docket Management Facility, M-30, U.S. Department of 
Transportation, West Building, Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE., Washington, DC 20590.
     Hand Delivery or Courier: West Building, Ground Floor, 
Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590, between 
9 a.m. and 5 p.m. Eastern Time, Monday through Friday, except Federal 
holidays. Telephone: 1-800-647-2251.
     Instructions: All submissions must include the docket 
number for this document. Please identify the collection of information 
for which a comment is provided by referencing the OMB Control Number, 
2127-0635. Note that all comments received will be posted without 
change to http://www.regulations.gov, including any personal 
information provided. Please see the Privacy Act heading below.
    Privacy Act: Anyone is able to search the electronic form of all 
comments received into any of our dockets by tile name of the 
individual submitting the comment (or signing the comment, if submitted 
on behalf of an association, business, labor union, etc.). You may 
review DOT's complete Privacy Act Statement in the Federal Register 
published on April 11, 2000 (65 FR 19477-78) or you may visit http://Docketslnfo.dot.gov.

FOR FURTHER INFORMATION CONTACT: Ms. Gayle Dalrymple, NHTSA, 1200 New 
Jersey Avenue SE., Room W45-333, NVS-123, Washington, DC 20590. Ms. 
Dalrymple's telephone number is (202) 366-5559.

[[Page 20173]]


SUPPLEMENTARY INFORMATION: Under the Paperwork Reduction Act of 1995, 
before an agency submits a proposed collection of information to OMB 
for approval, it must first publish a document in the Federal Register 
providing a 60-day comment period and otherwise consult with members of 
the public and affected agencies concerning each proposed collection of 
information. The OMB has promulgated regulations describing what must 
be included in such a document. Under OMB's regulation (at 5 CFR 
1320.8(d)), an agency must ask for public comment on the following:
    (1) Whether the proposed collection of information is necessary for 
the proper performance of the functions of the agency, including 
whether the information will have practical utility;
    (2) The accuracy of the agency's estimate of the burden of the 
proposed collection of information, including the validity of the 
methodology and assumptions used;
    (3) How to enhance the quality, utility, and clarity of the 
information to be collected;
    (4) How to minimize the burden of the collection of information on 
those who are to respond, including the use of appropriate automated, 
electronic, mechanical, or other technological collection techniques or 
other forms of information technology, e.g., permitting electronic 
submission of responses.
    In compliance with these requirements, NHTSA asks for public 
comments on the following collection of information:
    Title: Exemption for the Make Inoperative Prohibition.
    OMB Control Number: 2127-0635.
    Form Number: This collection of information uses no standard form.
    Type of Request: Extension of a currently approved collection of 
information.
    Abstract: On February 27, 2001, NHTSA published a final rule (66 
FR12638) to facilitate the modification of motor vehicles so that 
persons with disabilities can drive or ride in them as passengers. In 
that final rule, the agency issued a limited exemption from a statutory 
provision that prohibits specified types of commercial entities from 
either removing safety equipment or features installed on motor 
vehicles pursuant to the Federal motor vehicle safety standards or 
altering the equipment or features so as to adversely affect their 
performance. The exemption is limited in that it allows repair 
businesses to modify only certain types of Federally-required safety 
equipment and features, under specified circumstances. The regulation 
is found at 49 CFR Part 595 Subpart C, ``Vehicle Modifications to 
Accommodate People with Disabilities.''
    This final rule included two new ``collections of information,'' as 
that term is defined in 5 CFR Part 1320 ``Controlling Paperwork Burdens 
on the Public'': Modifier identification and a document to be provided 
to the owner of the modified vehicle stating the exemptions used for 
that vehicle and any reduction in load carrying capacity of the vehicle 
of more than 100 kg (220 lbs).
    Modifiers who take advantage of the exemption created by this rule 
are required to furnish NHTSA with a written document providing the 
modifier's name, address, and telephone number, and a statement that 
the modifier is availing itself of the exemption. The rule requires:
    ``S595.6 Modifier Identification.
    (a) Any motor vehicle repair business that modifies a motor vehicle 
to enable a person with a disability to operate, or ride as a passenger 
in, the motor vehicle and intends to avail itself of the exemption 
provided in 49 CFR 595.7 shall furnish the information specified in 
paragraphs (a)(1) through (3) of this section to: Administrator, 
National Highway Traffic Safety Administration, 400 Seventh Street SW., 
Washington, DC 20590.\1\
---------------------------------------------------------------------------

    \1\ The address of NHTSA has changed since 2001 and is now 1200 
New Jersey Ave. SE., Washington, DC 20590.
---------------------------------------------------------------------------

    (1) Full individual, partnership, or corporate name of the motor 
vehicle repair business.
    (2) Residence address of the motor vehicle repair business and 
State of incorporation if applicable.
    (3) A statement that the motor vehicle repair business modifies a 
motor vehicle to enable a person with a disability to operate, or ride 
as a passenger in, the motor vehicle and intends to avail itself of the 
exemption provided in 49 CFR 595.7.
    (b) Each motor vehicle repair business required to submit 
information under paragraph (a) of this section shall submit the 
information not later than August 27, 2001. After that date, each motor 
vehicle repair business that modifies a motor vehicle to enable a 
person with a disability to operate, or ride as a passenger in, the 
motor vehicle and intends to avail itself of the exemption provided in 
49 CFR 595.7 shall submit the information required under paragraph (a) 
not later than 30 days after it first modifies a motor vehicle to 
enable a person with a disability to operate, or ride as a passenger 
in, the motor vehicle. Each motor vehicle repair business who has 
submitted required information shall keep its entry current, accurate 
and complete by submitting revised information not later than 30 days 
after the relevant changes in the business occur.''
    This requirement is a one-time submission unless changes are made 
to the business as described in paragraph (b). NHTSA estimates that 
there are currently 700 businesses making modifications to motor 
vehicles to accommodate persons with disabilities. Of those 700, we 
estimate 85 percent will need to use the exemptions provided by 49 CFR 
595.7 (595 businesses). The initial registration of modifiers wishing 
to use the exemptions occurred in 2001. Based on letters received since 
then, we estimate that 90 businesses currently modifying vehicles will 
need to change their information or new registrants will elect to use 
the exemptions annually. We estimate the burden of new or changed 
registrations from 90 businesses each year of: 90 businesses x 10 
minutes/business = 15 hours.
    We estimate the material cost associated with each submission to be 
56 cents per responding business, or $50.04 nationwide annually.
    Burden means the total time, effort, or financial resources 
expended by a person to generate, maintain, retain, disclose or provide 
information to or for a Federal agency. This includes the time needed 
to review instruction; develop, acquire, install, and utilize 
technology and systems for the purposes of collecting, validating, and 
verifying information, processing and maintaining information and 
disclosing and providing information; adjust the existing ways to 
comply with any previously applicable instructions and requirements; 
train personnel to be able to respond to a collection of information; 
and transmit or otherwise disclose the information.
    We seek comment on:
    1. Is our estimate of 700 businesses engaged in vehicle 
modification to accommodate people with disabilities correct?
    2. Are we correct in assuming that a maximum of 85 percent of those 
700 businesses, or 595 businesses, will need to use the exemptions 
provided by 49 CFR 595.7?
    3. Are our estimates of the burden hours and material cost of 
compliance with 49 CFR 595.6 reasonable?
    Modifiers who avail themselves of the exemptions in 49 CFR 595.7 
are required to keep a record, for each applicable vehicle, listing 
which standards, or portions thereof, no longer

[[Page 20174]]

comply with the Federal motor vehicle safety standards and to provide a 
copy to the owner of the vehicle modified (see 49 CFR 595.7 (b) and (e) 
as published in the final rule).
    We estimate that:
    1. There are approximately 4013 vehicles modified for persons with 
disabilities per year by 700 businesses; \2\
---------------------------------------------------------------------------

    \2\ The agency does not require modifiers to submit information 
to us for every vehicle that is modified. Therefore, we have no 
exact count of the number of modifications made each year.
---------------------------------------------------------------------------

    2. If 85 percent of the 700 businesses use the exemptions provided 
by 49 CFR 595.7, those 595 businesses will modify 3411 vehicles 
annually; and
    3. The burden for producing the record required by 49 CFR 595.7 in 
accordance with paragraph (e) for those vehicles will be 1137 hours per 
year nationwide.
    In the final rule we anticipated that the least costly way for a 
repair business to comply with this portion of the new rule would be to 
annotate the vehicle modification invoice as to the exemption, if any, 
involved with each item on the invoice. The cost of preparing the 
invoice is not a portion of our burden calculation, as that preparation 
would be done in the normal course of business. The time needed to 
annotate the invoice, we estimate, is 20 minutes. Therefore, the burden 
hours for a full year are calculated as: 3411 vehicles x 20 minutes/
vehicle = 1137 hours.
    This burden includes the calculation required by 49 CFR 595.7(e), 
but not the gathering of the information required for the calculation. 
That information would be gathered in the normal course of the vehicle 
modification. The only extra burden required by the rule is the 
calculation of the reduction in loading carrying capacity and conveying 
this information to the vehicle owner. Again, we are assuming that 
annotation on the invoice is the least burdensome way to accomplish 
this customer notification.
    There will be no additional material cost associated with 
compliance with this requirement since no additional materials need be 
used above those used to prepare the invoice in the normal course of 
business. We are assuming it is normal and customary in the course of 
vehicle modification business to prepare an invoice, to provide a copy 
of the invoice to the vehicle owner, and to keep a copy of the invoice 
for five years after the vehicle is delivered to the owner in finished 
form.
    We seek comment on whether our assumptions about the following are 
reasonable:
    1. The document required by 49 CFR595.7(b) and specified in 
paragraph (e) will need to be prepared for approximately 3411 vehicles 
modified nationwide per year,
    2. Annotation of each vehicle modification invoice as to which 
exemptions were used will take an average of 20 minutes, and
    3. It is normal in the course of vehicle modification business to 
prepare an invoice, to provide a copy of the invoice to the vehicle 
owner, and to keep a copy of the invoice for five years after the 
vehicle is delivered to the owner in finished form.
    Affected Public: Business or other for profit.
    Estimated Annual Burden: 1152 hours, and $50.04
    Estimated Number of Respondents: 595.
    Comments are invited on: Whether the proposed collection of 
information is necessary for the proper performance of the functions of 
the Department, including whether the information will have practical 
utility; the accuracy of the Department's estimate of the burden of the 
proposed information collection; ways to enhance the quality, utility 
and clarity of the information to be collected; and ways to minimize 
the burden of the collection of information on respondents, including 
the use of automated collection techniques or other forms of 
information technology.

    Issued on: March 28, 2013.
Christopher J. Bonanti,
Associate Administrator for Rulemaking .
[FR Doc. 2013-07762 Filed 4-2-13; 8:45 am]
BILLING CODE 4910-59-P


