
[Federal Register Volume 77, Number 33 (Friday, February 17, 2012)]
[Notices]
[Pages 9726-9727]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 2012-3766]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration

[Docket No. NHTSA-2012-0019; Notice 1]


Utilimaster Corporation, Receipt of Petition for Decision of 
Inconsequential Noncompliance

AGENCY: National Highway Traffic Safety Administration, DOT.

ACTION: Receipt of Petition.

-----------------------------------------------------------------------

SUMMARY: Utilimaster Corporation (Utilimaster) \1\ has determined that 
certain model year 2009-2011 Utilimaster walk-in van-type trucks 
manufactured between September 1, 2009, and December 22, 2011, do not 
fully comply with paragraph S4.2.1 of Federal Motor Vehicle Safety 
Standard (FMVSS) No. 206, Door Locks and Door Retention Components. 
Utilimaster has filed an appropriate report dated December 30, 2011, 
pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility 
and Reports.
---------------------------------------------------------------------------

    \1\ Utilimaster Corporation, a wholly owned subsidiary of 
Spartan Motors, Inc., is manufacturer of motor vehicles and is 
registered under the laws of Delaware.
---------------------------------------------------------------------------

    Pursuant to 49 U.S.C. 30118(d) and 30120(h) (see implementing rule 
at 49 CFR part 556), Spartan Motors, Inc.,\2\ on behalf of Utilimaster 
has submitted a petition for an exemption from the notification and 
remedy requirements of 49 U.S.C. Chapter 301 on the basis that this 
noncompliance is inconsequential to motor vehicle safety.
---------------------------------------------------------------------------

    \2\ Spartan Motors, Inc., is a manufacturer of motor vehicles 
and is registered under the laws of the state of Michigan.
---------------------------------------------------------------------------

    This notice of receipt of Utilimaster's petition is published under 
49 U.S.C. 30118 and 30120 and does not represent any agency decision or 
other exercise of judgment concerning the merits of the petition.
    Affected are approximately 9,861 model year 2009-2011 Utilimaster 
walk-in van-type trucks manufactured between September 1, 2009, and 
December 22, 2011.
    NHTSA notes that the statutory provisions (49 U.S.C. 30118(d) and 
30120(h)) that permit manufacturers to file petitions for a 
determination of inconsequentiality allow NHTSA to exempt manufacturers 
only from the duties found in sections 30118 and 30120, respectively, 
to notify owners, purchasers, and dealers of a defect or noncompliance 
and to remedy the defect or noncompliance. Therefore, these provisions 
only apply to the subject 9,861 \3\ model year 2009-2011 trucks that 
Utilimaster no longer controlled at the time it determined that the 
noncompliance existed.
---------------------------------------------------------------------------

    \3\ Utilimaster's petition, which was filed under 49 CFR part 
556, requests an agency decision to exempt Utilimaster as a vehicle 
manufacturer from the notification and recall responsibilities of 49 
CFR part 573 for the 9,861 affected vehicles. However, a decision on 
this petition cannot relieve vehicle distributors and dealers of the 
prohibitions on the sale, offer for sale, introduction or delivery 
for introduction into interstate commerce of the noncompliant 
vehicles under their control after Utilimaster notified them that 
the subject noncompliance existed.
---------------------------------------------------------------------------

    Utilimaster explains that the noncompliance is that while the 
sliding doors on the vehicles are equipped with a door latch system 
with a fully latched position, no door closure warning system, as 
required by paragraph S4.2.1 of FMVSS No. 206, is installed.
    Paragraph S4.2.1 of FMVSS No. 206 requires in pertinent part:

    S4.2 Sliding Side Doors.
    S4.2.1 Latch System. Each sliding door system shall be equipped 
with either:
    (a) At least one primary door latch system, or
    (b) A door latch system with a fully latched position and a door 
closure warning system. The door closure warning system shall be 
located where it can be clearly seen by the driver. Upon 
certification a manufacturer may not thereafter alter the 
designation of a primary latch. Each manufacturer shall, upon 
request from the National Highway Traffic Safety Administration, 
provide information regarding such designation * * *

Summary of Utilimaster's Analysis and Arguments

    The sliding door latch requirements contained in paragraph S4.2.1 
of FMVSS No. 206 were adopted in February 2007 as part of a broader 
upgrade to the Agency's existing door latch and retention requirements. 
The standard defines ``Primary Door Latch'' as ``a latch equipped with 
both a fully latched position and a secondary latched position and is 
designated as a `primary door latch' by the manufacturer.'' It defines 
``Door Closure Warning System'' as ``a system that will activate a 
visual signal when a door latch system is not in its fully latched 
position and the vehicle ignition is activated.'' The effective date of 
these requirements was September 1, 2009. (The load test requirements 
of paragraph S4.2.2 of FMVSS No. 206 became effective September 1, 
2010; the subject vehicles do comply with the load requirements.)
    As set forth in Utilimaster's noncompliance report, Utilimaster 
determined that the new latch requirements applied to these vehicles, 
but were not designed into vehicles built after the effective date. 
(This omission was the result of Utilmaster's previous 
misinterpretation as to the applicability of the FMVSS No. 206 
amendments to these particular vehicles.)
    Specifically, the sliding doors on the subject vehicles are 
equipped with a door latch that does not meet the above-referenced 
definition of a ``primary door latch,'' because these vehicles lack a 
secondary latched position. Thus, these vehicles do not meet the 
paragraph S4.2.1(a) compliance option. Moreover, these vehicles are not 
equipped with a ``door closure warning system'' and, therefore, they do 
not meet the paragraph S4.2.1(b) compliance option. In any event, we 
believe that the omission of a door closure warning system on these 
vehicles is inconsequential to safety. This is due to the particular 
characteristics of the sliding doors on these vehicles, which will 
immediately provide adequate visual (and audible) feedback to the 
driver to alert him or her in the event a door is unlatched.
    The door has approximately 0.315 inches of engagement into the door 
seal. Therefore, should the sliding door not be in the latched 
position, it would be readily apparent to the driver before the vehicle 
is driven.
    Even if the driver did not notice the gap in the door prior to the 
vehicle being driven, these doors would provide immediate visual 
feedback to the driver as soon as the vehicle begins to move. The 
sliding doors, on these vehicles, are designed to slide longitudinally 
on a track when the sliding door handle is activated and a small force 
is applied in the same longitudinal direction. As a

[[Page 9727]]

consequence, if the sliding door is not fully closed and latched and 
the driver is not aware, this fact would become immediately apparent to 
the driver when the vehicle is accelerated from rest, as the sliding 
door would glide rearward from the force created by the acceleration. 
Thus, while these vehicles may not meet the express requirements of 
paragraph S4.2.1 or the definition of a ``door closure warning 
system,'' Utilimaster believes they do meet the intent of these 
requirements. The use of other visual signals, such as a dash-mounted 
telltale, might be necessary for vehicles with rear sliding doors, such 
as minivans or other passenger vehicles, but the sliding doors on the 
subject vehicles are located in the front within plain view of the 
driver.
    In adopting the upgraded sliding door standards in 2007, the Agency 
stated that it was particularly concerned with children riding in the 
rear seats of passenger vans (minivans or ``MPVs'').\4\
---------------------------------------------------------------------------

    \4\ 72 FR 5387.
---------------------------------------------------------------------------

    As noted above, these vehicles are used exclusively in commercial 
applications and are driven exclusively by professional drivers 
(primarily without a passenger). The commercial application of walk-in 
vans is highly repetitive in nature. To ensure safety and to maximize 
productivity, corporations have adopted highly regimented training 
programs for drivers in addition to requiring them to carry a 
commercial driver's license. The regimented training for the high 
majority of commercial applications requires that drivers enter and 
exit the vehicle from the curb side of the van. The repetitive use of 
the van results in highly repeatable results from one stop to the next. 
The likelihood that a driver would move the vehicle with the door left 
inadvertently open is very low. Moreover, the likelihood that the 
driver would be ejected from the driver's seat, through a curb-side 
door, left unintentionally unlatched, is even less probable. These 
drivers must adhere to corporate policies as they relate to operating 
the vehicle. For example, UPS has strictly enforced requirements for 
the drivers to always have the seatbelts fastened when the vehicle is 
in motion. Walk-In vans with sliding doors very similar in design to 
those on the subject vehicles have been in use for several decades. We 
are not aware of a driver or passenger ever having been ejected from, 
or fallen through an open sliding cab door, of our vehicles, while the 
vehicle was in motion.
    The sliding doors on these vehicles meet all load test and inertial 
requirements of FMVSS No. 206, paragraph S4.2. Therefore, this 
noncompliance will not increase the risk of occupant ejection under 
conditions addressed by such requirements.
    In summation, Utilimaster believes that the described noncompliance 
of its vehicles is inconsequential to motor vehicle safety, and that 
its petition, to exempt from providing recall notification of 
noncompliance as required by 49 U.S.C. 30118 and remedying the recall 
noncompliance as required by 49 U.S.C. 30120 should be granted.
    Comments: Interested persons are invited to submit written data, 
views, and arguments on this petition. Comments must refer to the 
docket and notice number cited at the beginning of this notice and be 
submitted by any of the following methods:
    a. By mail addressed to: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE., Washington, DC 20590.
    b. By hand delivery to U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE., Washington, DC 20590. The Docket Section is open on 
weekdays from 10 a.m. to 5 p.m. except Federal holidays.
    c. Electronically: By logging onto the Federal Docket Management 
System (FDMS) Web site at http://www.regulations.gov/. Follow the 
online instructions for submitting comments. Comments may also be faxed 
to 1-202-493-2251.
    Comments must be written in the English language, and be no greater 
than 15 pages in length, although there is no limit to the length of 
necessary attachments to the comments. If comments are submitted in 
hard copy form, please ensure that two copies are provided. If you wish 
to receive confirmation that your comments were received, please 
enclose a stamped, self-addressed postcard with the comments. Note that 
all comments received will be posted without change to http://www.regulations.gov, including any personal information provided.
    Documents submitted to a docket may be viewed by anyone at the 
address and times given above. The documents may also be viewed on the 
Internet at http://www.regulations.gov by following the online 
instructions for accessing the dockets. DOT's complete Privacy Act 
Statement is available for review in the Federal Register published on 
April 11, 2000, (65 FR 19477-78).
    The petition, supporting materials, and all comments received 
before the close of business on the closing date indicated below will 
be filed and will be considered. All comments and supporting materials 
received after the closing date will also be filed and will be 
considered to the extent possible. When the petition is granted or 
denied, notice of the decision will be published in the Federal 
Register pursuant to the authority indicated below.

DATES: Comment Closing Date: March 19, 2012.

    Authority: (49 U.S.C. 30118, 30120: delegations of authority at 
CFR 1.50 and 501.8)

    Issued on: February 13, 2012.
Claude H. Harris,
Director, Office of Vehicle Safety Compliance.
[FR Doc. 2012-3766 Filed 2-16-12; 8:45 am]
BILLING CODE 4910-59-P


