
[Federal Register: November 26, 2008 (Volume 73, Number 229)]
[Notices]               
[Page 72110-72111]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr26no08-124]                         


[[Page 72110]]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration

 
Petition for Exemption From the Vehicle Theft Prevention 
Standard; Fuji Heavy Industries U.S.A., Inc.

AGENCY: National Highway Traffic Safety Administration (NHTSA) 
Department of Transportation (DOT).

ACTION: Grant of petition for exemption.

-----------------------------------------------------------------------

SUMMARY: This document grants in full the Fuji Heavy Industries U.S.A., 
Inc.'s (FUSA) petition for exemption of the Subaru Outback vehicle line 
in accordance with 49 CFR part 543, Exemption from the Theft Prevention 
Standard. This petition is granted because the agency has determined 
that the antitheft device to be placed on the line as standard 
equipment is likely to be as effective in reducing and deterring motor 
vehicle theft as compliance with the parts-marking requirements of the 
Theft Prevention Standard (49 CFR part 541). FUSA requested 
confidential treatment for the information and attachments it submitted 
in support of its petition. The agency will address FUSA's request for 
confidential treatment by separate letter.

DATES: The exemption granted by this notice is effective beginning with 
model year (MY) 2010.

FOR FURTHER INFORMATION CONTACT: Ms. Deborah Mazyck, International 
Policy, Fuel Economy and Consumer Programs, NHTSA, 1200 New Jersey 
Avenue, SE., Washington, DC 20590. Ms. Mazyck's phone number is (202) 
366-0846. Her fax number is (202) 493-2990.

SUPPLEMENTARY INFORMATION: In a petition dated July 31, 2008, FUSA 
requested an exemption from the parts-marking requirements of the theft 
prevention standard (49 CFR part 541) for the Subaru Outback vehicle 
line, beginning with the 2010 model year. The petition has been filed 
pursuant to 49 CFR Part 543, Exemption from Vehicle Theft Prevention 
Standard, based on the installation of an antitheft device as standard 
equipment for an entire vehicle line.
    Under Sec.  543.5(a), a manufacturer may petition NHTSA to grant 
exemptions for one of its vehicle lines per model year. In its 
petition, FUSA provided a detailed description and diagram of the 
identity, design, and location of the components of the antitheft 
device for the Outback vehicle line. FUSA stated that all Subaru 
Outback vehicles will be equipped with a passive, transponder-based 
electronic immobilizer device as standard equipment. FUSA stated that 
the antitheft system and the immobilization features are designed and 
constructed within the vehicle's Controller Area Network electrical 
architecture. Major components of the antitheft device will include an 
electronic key, a passive immobilizer system, a key ring antenna and an 
engine control unit. System immobilization is automatically activated 
when the key is removed from the vehicle's ignition switch, or after 30 
seconds if the ignition is simply moved to the off position and the key 
is not removed. The device will also have a visible and audible alarm, 
and panic mode feature. The alarm system will monitor door status and 
key identification. Unauthorized opening of a door will activate the 
alarm system causing sounding of the horn and flashing of the hazard 
lamps. FUSA's submission is considered a complete petition as required 
by 49 CFR 543.7 in that it meets the general requirements contained in 
543.5 and the specific content requirements of 543.6.
    FUSA also provided information on the reliability and durability of 
its proposed device, conducting tests based on its own specified 
standards. FUSA provided a list of the tests it conducted. FUSA 
believes that its device is reliable and durable because the device 
complied with its own specific requirements for each test. 
Additionally, FUSA stated that the immobilization features are designed 
and constructed within the vehicle's overall Controller Area Network 
Electrical Architecture. Therefore, the antitheft system cannot be 
separated and controlled.
    FUSA stated that it believes that historically, NHTSA has seen a 
decreasing theft rate trend when electronic immobilization has been 
added to alarm systems. FUSA stated that it presently has immobilizer 
systems on all of its product lines (Forester, Tribeca, Impreza, 
Legacy, and Outback models) and it believes the data shows 
immobilization has had a demonstrable effect in lowering its theft 
rates. FUSA also noted that recent state-by-state theft results from 
the National Insurance Crime Bureau reported that in only 3 of the 48 
states listed in its results, did any Subaru vehicle appear in the top 
10 list of stolen cars. Review of the theft rates published by the 
agency through MY/CY also revealed that, while there is some variation, 
the theft rates for Subaru vehicles have on average, remained below the 
median theft rate of 3.5826.
    FUSA also provided a comparative table showing how its device is 
similar to other manufacturer's devices that have already been granted 
an exemption by NHTSA. In its comparison, FUSA makes note of Federal 
Notices published by NHTSA in which manufacturers have stated that they 
have seen reductions in theft due to the immobilization systems being 
used. Specifically, FUSA notes claims by Ford Motor Company that its 
1997 Mustangs with immobilizers saw a 70% reduction in theft compared 
to its 1995 Mustangs without immobilizers. FUSA also noted its reliance 
on theft rates published by the agency which showed that theft rates 
were lower for Jeep Grand Cherokee immobilizer-equipped vehicles (model 
year 1995 through 1998) compared to older parts-marked Jeep Grand 
Cherokee vehicles (model year 1990 and 1991). FUSA stated that it 
believes that these comparisons show that its device is no less 
effective than those installed on lines for which the agency has 
already granted full exemption from the parts-marking requirements. The 
agency agrees that the device is substantially similar to devices in 
other vehicles lines for which the agency has already granted 
exemptions.
    Pursuant to 49 U.S.C. 33106 and 49 CFR 543.7(b), the agency grants 
a petition for an exemption from the parts-marking requirements of part 
541 either in whole or in part, if it determines that, based upon 
substantial evidence, the standard equipment antitheft device is likely 
to be as effective in reducing and deterring motor vehicle theft as 
compliance with the parts-marking requirements of part 541. The agency 
finds that FUSA has provided adequate reasons for its belief that the 
antitheft device will reduce and deter theft. This conclusion is based 
on the information FUSA provided about its device.
    The agency concludes that the device will provide the five types of 
performance listed in Sec.  543.6(a)(3): promoting activation; 
attracting attention to the efforts of unauthorized persons to enter or 
operate a vehicle by means other than a key; preventing defeat or 
circumvention of the device by unauthorized persons; preventing 
operation of the vehicle by unauthorized entrants; and ensuring the 
reliability and durability of the device.
    For the foregoing reasons, the agency hereby grants in full FUSA's 
petition for exemption for the vehicle line from the parts-marking 
requirements of 49 CFR part 541. The agency notes that 49 CFR part 541, 
Appendix A-1, identifies those lines that are exempted from the Theft 
Prevention Standard for a given model year. 49 CFR part 543.7(f) 
contains publication requirements incident to the disposition of all 
Part

[[Page 72111]]

543 petitions. Advanced listing, including the release of future 
product nameplates, the beginning model year for which the petition is 
granted and a general description of the antitheft device is necessary 
in order to notify law enforcement agencies of new vehicle lines 
exempted from the parts-marking requirements of the Theft Prevention 
Standard.
    If FUSA decides not to use the exemption for this line, it must 
formally notify the agency, and, thereafter, the line must be fully 
marked as required by 49 CFR parts 541.5 and 541.6 (marking of major 
component parts and replacement parts).
    NHTSA notes that if FUSA wishes in the future to modify the device 
on which this exemption is based, the company may have to submit a 
petition to modify the exemption. Part 543.7(d) states that a Part 543 
exemption applies only to vehicles that belong to a line exempted under 
this part and equipped with the anti-theft device on which the line's 
exemption is based. Further, Sec.  543.9(c)(2) provides for the 
submission of petitions ``to modify an exemption to permit the use of 
an antitheft device similar to but differing from the one specified in 
that exemption.''
    The agency wishes to minimize the administrative burden that Part 
543.9(c)(2) could place on exempted vehicle manufacturers and itself. 
The agency did not intend Part 543 to require the submission of a 
modification petition for every change to the components or design of 
an antitheft device. The significance of many such changes could be de 
minimis. Therefore, NHTSA suggests that if the manufacturer 
contemplates making any changes the effects of which might be 
characterized as de minimis, it should consult the agency before 
preparing and submitting a petition to modify.

    Authority: 49 U.S.C. 33106; delegation of authority at 49 CFR 
1.50.

    Issued on: November 20, 2008.
Stephen R. Kratzke,
Associate Administrator for Rulemaking.
[FR Doc. E8-28084 Filed 11-25-08; 8:45 am]

BILLING CODE 4910-59-P
