[Federal Register Volume 83, Number 14 (Monday, January 22, 2018)]
[Rules and Regulations]
[Pages 2894-2896]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2018-00949]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2018-0023; Product Identifier 2017-NM-084-AD; Amendment 
39-19164; AD 2018-02-11]
RIN 2120-AA64


Airworthiness Directives; Airbus Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for certain 
Airbus Model A330-301, -321, -322 and -342 airplanes. This AD requires 
contacting the FAA to obtain instructions for addressing the unsafe 
condition on these products, and doing the actions specified in those 
instructions. This AD was prompted by a report of cracking in the top 
skin of the horizontal stabilizer (HS) center box (CB) of an airplane 
in pre-modification 41330 configuration. We are issuing this AD to 
address the unsafe condition on these products.

DATES: This AD becomes effective February 6, 2018.
    We must receive comments on this AD by March 8, 2018.

ADDRESSES: You may send comments, using the procedures found in 14 CFR 
11.43 and 11.45, by any of the following methods:
     Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
     Fax: 202-493-2251.
     Mail: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE, Washington, DC 20590.
     Hand Delivery: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE, Washington, DC, between 9 a.m. and 5 p.m., Monday 
through Friday, except Federal holidays.

Examining the AD Docket

    You may examine the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-
0023; or in person at the Docket Operations office between 9 a.m. and 5 
p.m., Monday through Friday, except Federal holidays. The AD docket 
contains this AD, the regulatory evaluation, any comments received, and 
other information. The street address for the Docket Operations office 
(telephone: 800-647-5527) is in the ADDRESSES section. Comments will be 
available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Vladimir Ulyanov, Aerospace Engineer, 
International Section, Transport Standards Branch, FAA, 1601 Lind 
Avenue SW, Renton, WA 98057-3356; telephone: 425-227-1138; fax: 425-
227-1149.

SUPPLEMENTARY INFORMATION: 

Discussion

    The European Aviation Safety Agency (EASA), which is the Technical 
Agent for the Member States of the European Union, has issued EASA AD 
2017-0078, dated May 3, 2017 (referred to after this as the Mandatory 
Continuing Airworthiness Information, or ``the MCAI''), to correct an 
unsafe condition for certain Airbus Model A330-301, -321, -322 and -342 
airplanes. The MCAI states:

    Cracks were found in the horizontal stabilizer (HS) centre box 
(CB) top skin of an aeroplane in pre-modification 41330 
configuration. The cracks were initiated at the upper flange corner 
at Rib 3 rear spar area on left hand side of the CB.
    This condition, if not detected and corrected, could lead to 
reduced structural integrity of the HS CB of the aeroplane.
    To address this unsafe condition, Airbus published Service 
Bulletin (SB) A330-55-3046 to provide inspection instructions for 
the affected area.
    For the reason described above, this [EASA] AD requires a one-
time special detailed inspection (SDI) of the HS CB top

[[Page 2895]]

skin integral flange area and, depending on findings, accomplishment 
of applicable corrective action(s). This [EASA] AD also requires 
reporting of the inspection results, including no findings, to 
Airbus.

    You may examine the MCAI on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-
0023.

FAA's Determination and Requirements of This AD

    This product has been approved by the aviation authority of another 
country, and is approved for operation in the United States. Pursuant 
to our bilateral agreement with the State of Design Authority, we have 
been notified of the unsafe condition described in the MCAI. We are 
issuing this AD because we evaluated all pertinent information and 
determined the unsafe condition exists and is likely to exist or 
develop on other products of the same type design.

FAA's Determination of the Effective Date

    Since there are currently no domestic operators of this product, we 
find good cause that notice and opportunity for prior public comment 
are unnecessary. In addition, for the reasons stated above, we find 
that good cause exists for making this amendment effective in less than 
30 days.

Comments Invited

    This AD is a final rule that involves requirements affecting flight 
safety, and we did not precede it by notice and opportunity for public 
comment. We invite you to send any written relevant data, views, or 
arguments about this AD. Send your comments to an address listed under 
the ADDRESSES section. Include ``Docket No. FAA-2018-0023; Product 
Identifier 2017-NM-084-AD'' at the beginning of your comments. We 
specifically invite comments on the overall regulatory, economic, 
environmental, and energy aspects of this AD. We will consider all 
comments received by the closing date and may amend this AD based on 
those comments.
    We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We 
will also post a report summarizing each substantive verbal contact we 
receive about this AD.

Costs of Compliance

    Currently, there are no affected U.S.-registered airplanes. This AD 
requires contacting the FAA to obtain instructions for addressing the 
unsafe condition, and doing the actions specified in those 
instructions. Based on the actions specified in the MCAI AD, we are 
providing the following cost estimates for an affected airplane that is 
placed on the U.S. Register in the future:

                                                 Estimated Costs
----------------------------------------------------------------------------------------------------------------
                                                                                                     Cost per
                   Action                                 Labor cost                Parts cost        product
----------------------------------------------------------------------------------------------------------------
High frequency eddy current inspection.....  1 work-hour x $85 per hour = $85...              $0             $85
Reporting..................................  1 work-hour x $85 per hour = $85...               0              85
----------------------------------------------------------------------------------------------------------------

    We have received no definitive data that would enable us to provide 
cost estimates for the on-condition actions specified in this AD.

Paperwork Reduction Act

    A federal agency may not conduct or sponsor, and a person is not 
required to respond to, nor shall a person be subject to penalty for 
failure to comply with a collection of information subject to the 
requirements of the Paperwork Reduction Act unless that collection of 
information displays a current valid OMB control number. The control 
number for the collection of information required by this AD is 2120-
0056. The paperwork cost associated with this AD has been detailed in 
the Costs of Compliance section of this document and includes time for 
reviewing instructions, as well as completing and reviewing the 
collection of information. Therefore, all reporting associated with 
this AD is mandatory. Comments concerning the accuracy of this burden 
and suggestions for reducing the burden should be directed to the FAA 
at 800 Independence Ave. SW, Washington, DC 20591, ATTN: Information 
Collection Clearance Officer, AES-200.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.
    This AD is issued in accordance with authority delegated by the 
Executive Director, Aircraft Certification Service, as authorized by 
FAA Order 8000.51C. In accordance with that order, issuance of ADs is 
normally a function of the Compliance and Airworthiness Division, but 
during this transition period, the Executive Director has delegated the 
authority to issue ADs applicable to transport category airplanes to 
the Director of the System Oversight Division.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed above, I certify that this AD:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979);
    3. Will not affect intrastate aviation in Alaska; and
    4. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

[[Page 2896]]

Adoption of the Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new airworthiness 
directive (AD):

2018-02-11 Airbus: Amendment 39-19164; Docket No. FAA-2018-0023; 
Product Identifier 2017-NM-084-AD.

(a) Effective Date

    This AD becomes effective February 6, 2018.

(b) Affected ADs

    None.

(c) Applicability

    This AD applies to Airbus Model A330-301, -321, -322 and A330-
342 airplanes, certificated in any category, manufacturer serial 
numbers 0012, 0017, 0030, 0037, 0045, 0050, 0060, 0062, 0064, 0065, 
0071, 0082, 0083, 0098, 0099, 0102, 0106, 0109, 0112, 0132 and 0177.

(d) Subject

    Air Transport Association (ATA) of America Code 55, Stabilizers.

(e) Reason

    This AD was prompted by a report of cracking in the top skin of 
the horizontal stabilizer (HS) center box (CB) of an airplane in 
pre-modification 41330 configuration. We are issuing this AD to 
detect and correct cracking in the HS CB, which could lead to 
reduced structural integrity of the airplane.

(f) Compliance

    Comply with this AD within the compliance times specified, 
unless already done.

(g) Required Action(s)

    Within 30 days after the effective date of this AD, request 
instructions from the Manager, International Section, Transport 
Standards Branch, FAA, to address the unsafe condition specified in 
paragraph (e) of this AD; and accomplish the actions at the times 
specified in, and in accordance with, those instructions. Guidance 
can be found in Mandatory Continuing Airworthiness Information 
(MCAI) European Aviation Safety Agency (EASA) AD 2017-0078, dated 
May 3, 2017.

(h) Alternative Methods of Compliance (AMOCs)

    The Manager, International Section, Transport Standards Branch, 
FAA, has the authority to approve AMOCs for this AD, if requested 
using the procedures found in 14 CFR 39.19. In accordance with 14 
CFR 39.19, send your request to your principal inspector or local 
Flight Standards District Office, as appropriate. If sending 
information directly to the International Section, send it to the 
attention of the person identified in paragraph (j)(2) of this AD. 
Information may be emailed to: [email protected]. 
Before using any approved AMOC, notify your appropriate principal 
inspector, or lacking a principal inspector, the manager of the 
local flight standards district office/certificate holding district 
office.

(i) Paperwork Reduction Act Burden Statement

    A federal agency may not conduct or sponsor, and a person is not 
required to respond to, nor shall a person be subject to a penalty 
for failure to comply with a collection of information subject to 
the requirements of the Paperwork Reduction Act unless that 
collection of information displays a current valid OMB Control 
Number. The OMB Control Number for this information collection is 
2120-0056. Public reporting for this collection of information is 
estimated to be approximately 1 hour per response, including the 
time for reviewing instructions, completing and reviewing the 
collection of information. All responses to this collection of 
information are mandatory. Comments concerning the accuracy of this 
burden and suggestions for reducing the burden should be directed to 
the FAA at: 800 Independence Ave. SW, Washington, DC 20591, Attn: 
Information Collection Clearance Officer, AES-200.

(j) Related Information

    (1) Refer to MCAI EASA AD 2017-0078, dated May 3, 2017, for 
related information. You may examine the MCAI on the internet at 
http://www.regulations.gov by searching for and locating Docket No. 
FAA-2018-0023.
    (2) For more information about this AD, contact Vladimir 
Ulyanov, Aerospace Engineer, International Section, Transport 
Standards Branch, FAA, 1601 Lind Avenue SW, Renton, WA 98057-3356; 
telephone: 425-227-1138; fax: 425-227-1149.

(k) Material Incorporated by Reference

    None.

    Issued in Renton, Washington, on January 10, 2018.
John P. Piccola, Jr.,
Acting Director, System Oversight Division, Aircraft Certification 
Service.
[FR Doc. 2018-00949 Filed 1-19-18; 8:45 am]
 BILLING CODE 4910-13-P


