
[Federal Register Volume 82, Number 57 (Monday, March 27, 2017)]
[Rules and Regulations]
[Pages 15126-15128]
From the Federal Register Online via the Government Publishing Office [www.gpo.gov]
[FR Doc No: 2017-05233]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2016-9300; Directorate Identifier 2016-NM-124-AD; 
Amendment 39-18829; AD 2017-06-05]
RIN 2120-AA64


Airworthiness Directives; The Boeing Company Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for all The 
Boeing Company Model DC-6, DC-6A, C-118A, R6D-1, DC-6B, and R6D-1Z 
airplanes. This AD was prompted by a report of a fuel leak in a Model 
C-118A airplane that resulted from a crack in the wing lower skin. This 
AD requires repetitive radiographic, electromagnetic testing high 
frequency (ETHF), and electromagnetic testing low frequency (ETLF) 
inspections for cracking of the wing lower skin, and repairs if 
necessary. We are issuing this AD to address the unsafe condition on 
these products.

DATES: This AD is effective May 1, 2017.
    The Director of the Federal Register approved the incorporation by 
reference of a certain publication listed in this AD as of May 1, 2017.

ADDRESSES: For service information identified in this final rule, 
contact Boeing Commercial Airplanes, Attention: Contractual & Data 
Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 
90740-5600; telephone 562-797-1717; Internet https://www.myboeingfleet.com. You may view this referenced service information 
at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., 
Renton, WA. For information on the availability of this material at the 
FAA, call 425-227-1221. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
9300.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
9300; or in person at the Docket Management Facility between 9 a.m. and 
5 p.m., Monday through Friday, except Federal holidays. The AD docket 
contains this AD, the regulatory evaluation, any comments received, and 
other information. The address for the Docket Office (phone: 800-647-
5527) is Docket Management Facility, U.S. Department of Transportation, 
Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 
New Jersey Avenue SE., Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT: George Garrido, Aerospace Engineer, 
Airframe Branch, ANM-120L, FAA, Los Angeles Aircraft Certification 
Office (ACO), 3960 Paramount Boulevard, Lakewood, CA 90712-4137; phone: 
562-627-5232; fax: 562-627-5210; email: george.garride@faa.gov.

SUPPLEMENTARY INFORMATION: 

Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR 
part 39 by adding an AD that would apply to all The Boeing Company 
Model DC-6, DC-6A, C-118A, R6D-1, DC-6B, and R6D-1Z airplanes. The NPRM 
published in the Federal Register on October 26, 2016 (81 FR 74352). 
The NPRM was prompted by a report of a fuel leak in a Model C-118A 
airplane that resulted from a crack in the wing lower skin. The NPRM 
proposed to require repetitive radiographic, ETHF, and ETLF inspections 
for cracking of the wing lower skin just inboard of the number 2 
nacelle attach angle at wing station 175, and repairs if necessary. We 
are issuing this AD to detect and correct fatigue cracking in the wing 
lower skin, which could adversely affect the structural integrity of 
the wing.

Comments

    We gave the public the opportunity to participate in developing 
this AD. We have considered the comments received. The National 
Transportation Safety Board, Boeing, and Ms. Ana Maria expressed their 
support for the NPRM.

[[Page 15127]]

Conclusion

    We reviewed the relevant data, considered the comments received, 
and determined that air safety and the public interest require adopting 
this AD as proposed, except for minor editorial changes. We have 
determined that these minor changes:
     Are consistent with the intent that was proposed in the 
NPRM for correcting the unsafe condition; and
     Do not add any additional burden upon the public than was 
already proposed in the NPRM.

Related Service Information Under 1 CFR Part 51

    We reviewed Boeing Alert Service Bulletin DC6-57A001, dated April 
28, 2016. The service information describes procedures for 
radiographic, ETHF, and ETLF inspections for cracking of the wing lower 
skin at wing station 175, and repairs. This service information is 
reasonably available because the interested parties have access to it 
through their normal course of business or by the means identified in 
the ADDRESSES section.

Costs of Compliance

    We estimate that this AD affects 36 airplanes of U.S. registry. We 
estimate the following costs to comply with this AD:

                                                 Estimated Costs
----------------------------------------------------------------------------------------------------------------
                                                                                                 Cost on U.S.
           Action                    Labor cost           Parts cost      Cost per product        operators
----------------------------------------------------------------------------------------------------------------
Inspections.................  17 work-hours x $85 per               $0  $1,445 per           $52,020 per
                               hour = $1,445 per                         inspection cycle.    inspection cycle.
                               inspection cycle.
----------------------------------------------------------------------------------------------------------------

    We have received no definitive data that would enable us to provide 
cost estimates for the on-condition actions specified in this AD.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. Subtitle VII: Aviation Programs, 
describes in more detail the scope of the Agency's authority.
    We are issuing this rulemaking under the authority described in 
Subtitle VII, Part A, Subpart III, Section 44701: ``General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    This AD will not have federalism implications under Executive Order 
13132. This AD will not have a substantial direct effect on the States, 
on the relationship between the national government and the States, or 
on the distribution of power and responsibilities among the various 
levels of government.
    For the reasons discussed above, I certify that this AD:
    (1) Is not a ``significant regulatory action'' under Executive 
Order 12866,
    (2) Is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979),
    (3) Will not affect intrastate aviation in Alaska, and
    (4) Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13   [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new airworthiness 
directive (AD):

2017-06-05 The Boeing Company: Amendment 39-18829; Docket No. FAA-
2016-9300; Directorate Identifier 2016-NM-124-AD.

(a) Effective Date

    This AD is effective May 1, 2017.

(b) Affected ADs

    None.

(c) Applicability

    This AD applies to all The Boeing Company Model DC-6, DC-6A, DC-
6B, C-118A, R6D-1, and R6D-1Z airplanes, certificated in any 
category.

(d) Subject

    Air Transport Association (ATA) of America Code 57, Wings.

(e) Unsafe Condition

    This AD was prompted by a report of a fuel leak in a Model C-
118A airplane that resulted from a crack in the wing lower skin just 
inboard of the number 2 nacelle attach angle at wing station 175. We 
are issuing this AD to detect and correct fatigue cracking in the 
wing lower skin, which could adversely affect the structural 
integrity of the wing.

(f) Compliance

    Comply with this AD within the compliance times specified, 
unless already done.

(g) Repetitive Inspections

    Except as specified in paragraph (i) of this AD: At the 
applicable time specified in paragraph 1.E., ``Compliance,'' of 
Boeing Alert Service Bulletin DC6-57A001, dated April 28, 2016, do 
radiographic, electromagnetic testing high frequency (ETHF), and 
electromagnetic testing low frequency (ETLF) inspections for 
cracking of the wing lower skin at station 175, in accordance with 
the Accomplishment Instructions of Boeing Alert Service Bulletin 
DC6-57A001, dated April 28, 2016. Repeat the radiographic, ETHF, and 
ETLF inspections of any unrepaired areas thereafter at the 
applicable intervals specified in paragraph 1.E., ``Compliance,'' of 
Boeing Alert Service Bulletin DC6-57A001, dated April 28, 2016.

(h) Repairs

    If any cracking is found during any inspection required by this 
AD: Before further flight, repair the cracking using a method 
approved in accordance with the procedures specified in paragraph 
(j) of this AD.

(i) Service Information Exception

    Where paragraph 1.E., ``Compliance,'' of Boeing Alert Service 
Bulletin DC6-57A001, dated April 28, 2016, specifies a compliance 
time ``after the original issue date of this service bulletin,'' 
this AD requires compliance within the specified compliance time 
after the effective date of this AD.

[[Page 15128]]

(j) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, Los Angeles Aircraft Certification Office 
(ACO), FAA, has the authority to approve AMOCs for this AD, if 
requested using the procedures found in 14 CFR 39.19. In accordance 
with 14 CFR 39.19, send your request to your principal inspector or 
local Flight Standards District Office, as appropriate. If sending 
information directly to the manager of the ACO, send it to the 
attention of the person identified in paragraph (k) of this AD. 
Information may be emailed to: 9-ANM-LAACO-AMOC-Requests@faa.gov.
    (2) Before using any approved AMOC, notify your appropriate 
principal inspector, or lacking a principal inspector, the manager 
of the local flight standards district office/certificate holding 
district office.
    (3) An AMOC that provides an acceptable level of safety may be 
used for any repair, modification, or alteration required by this AD 
if it is approved by the Boeing Commercial Airplanes Organization 
Designation Authorization (ODA) that has been authorized by the 
Manager, Los Angeles ACO, to make those findings. To be approved, 
the repair method, modification deviation, or alteration deviation 
must meet the certification basis of the airplane, and the approval 
must specifically refer to this AD.
    (4) For service information that contains steps that are labeled 
as Required for Compliance (RC), the provisions of paragraphs 
(j)(4)(i) and (j)(4)(ii) of this AD apply.
    (i) The steps labeled as RC, including substeps under an RC step 
and any figures identified in an RC step, must be done to comply 
with the AD. If a step or substep is labeled ``RC Exempt,'' then the 
RC requirement is removed from that step or substep. An AMOC is 
required for any deviations to RC steps, including substeps and 
identified figures.
    (ii) Steps not labeled as RC may be deviated from using accepted 
methods in accordance with the operator's maintenance or inspection 
program without obtaining approval of an AMOC, provided the RC 
steps, including substeps and identified figures, can still be done 
as specified, and the airplane can be put back in an airworthy 
condition.

(k) Related Information

    For more information about this AD, contact George Garrido, 
Aerospace Engineer, Airframe Branch, ANM-120L, Los Angeles ACO, FAA, 
3960 Paramount Boulevard, Lakewood, CA 90712-4137; phone: 562-627-
5232; fax: 562-627-5210; email: george.garride@faa.gov.

(l) Material Incorporated by Reference

    (1) The Director of the Federal Register approved the 
incorporation by reference (IBR) of the service information listed 
in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
    (2) You must use this service information as applicable to do 
the actions required by this AD, unless the AD specifies otherwise.
    (i) Boeing Alert Service Bulletin DC6-57A001, dated April 28, 
2016.
    (ii) Reserved.
    (3) For Boeing service information identified in this AD, 
contact Boeing Commercial Airplanes, Attention: Contractual & Data 
Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 
90740-5600; telephone 562-797-1717; Internet https://www.myboeingfleet.com.
    (4) You may view this service information at the FAA, Transport 
Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For 
information on the availability of this material at the FAA, call 
425-227-1221.
    (5) You may view this service information that is incorporated 
by reference at the National Archives and Records Administration 
(NARA). For information on the availability of this material at 
NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

    Issued in Renton, Washington, on March 8, 2017.
Michael Kaszycki,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 2017-05233 Filed 3-24-17; 8:45 am]
 BILLING CODE 4910-13-P


