
[Federal Register Volume 79, Number 207 (Monday, October 27, 2014)]
[Rules and Regulations]
[Pages 63809-63811]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 2014-25406]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2014-0832; Directorate Identifier 2014-SW-044-AD; 
Amendment 39-17995; AD 2014-21-03]
RIN 2120-AA64


Airworthiness Directives; Airbus Helicopters (Previously 
Eurocopter France) Helicopters

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for Airbus 
Helicopters Model AS332L2 helicopters with a certain yaw control damper 
support (support) installed. This AD requires repetitively inspecting 
the support attachment points for a crack. This AD is prompted by a 
report that the front attachment points of several supports were found 
to have cracks. These actions are intended to detect a crack in a 
support, which could result in failure of the support, separation of 
the yaw damper unit, blocking of the yaw flight control channel, and 
reduced control of the helicopter.

DATES: This AD becomes effective November 12, 2014.
    We must receive comments on this AD by December 26, 2014.

ADDRESSES: You may send comments by any of the following methods:
     Federal eRulemaking Docket: Go to http://www.regulations.gov. Follow the online instructions for sending your 
comments electronically.
     Fax: 202-493-2251.
     Mail: Send comments to the U.S. Department of 
Transportation, Docket Operations, M-30, West Building Ground Floor, 
Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590-0001.
     Hand Delivery: Deliver to the ``Mail'' address between 9 
a.m. and 5 p.m., Monday through Friday, except Federal holidays.

[[Page 63810]]

Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the Docket Operations Office 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains this AD, the European Aviation Safety 
Agency (EASA) AD, any comments received, and other information. The 
street address for the Docket Operations Office (telephone 800-647-
5527) is in the ADDRESSES section. Comments will be available in the AD 
docket shortly after receipt.
    For service information identified in this AD, contact Airbus 
Helicopters, Inc., 2701 N. Forum Drive, Grand Prairie, TX 75052; 
telephone (972) 641-0000 or (800) 232-0323; fax (972) 641-3775; or at 
http://www.airbushelicopters.com/techpub. You may review the referenced 
service information at the FAA, Office of the Regional Counsel, 
Southwest Region, 2601 Meacham Blvd., Room 663, Fort Worth, Texas 
76137.

FOR FURTHER INFORMATION CONTACT: Rao Edupuganti, Aviation Safety 
Engineer, Regulations and Policy Group, Rotorcraft Directorate, FAA, 
2601 Meacham Blvd., Fort Worth, Texas 76137; telephone (817) 222-5110; 
email rao.edupuganti@faa.gov.

SUPPLEMENTARY INFORMATION: 

Comments Invited

    This AD is a final rule that involves requirements affecting flight 
safety, and we did not provide you with notice and an opportunity to 
provide your comments prior to it becoming effective. However, we 
invite you to participate in this rulemaking by submitting written 
comments, data, or views. We also invite comments relating to the 
economic, environmental, energy, or federalism impacts that resulted 
from adopting this AD. The most helpful comments reference a specific 
portion of the AD, explain the reason for any recommended change, and 
include supporting data. To ensure the docket does not contain 
duplicate comments, commenters should send only one copy of written 
comments, or if comments are filed electronically, commenters should 
submit them only one time. We will file in the docket all comments that 
we receive, as well as a report summarizing each substantive public 
contact with FAA personnel concerning this rulemaking during the 
comment period. We will consider all the comments we receive and may 
conduct additional rulemaking based on those comments.

Discussion

    This AD is prompted by AD No. 2014-0080, dated March 27, 2014, 
issued by EASA, which is the Technical Agent for the Member States of 
the European Union, to correct an unsafe condition for Airbus 
Helicopters Model AS332L2 helicopters with a support part number (P/N) 
332A25-1334-00 installed. EASA advises of several reports of cracks on 
the two front attachment points of the support, and that subsequent 
investigations determined pilot actions on the yaw pedals could 
generate detrimental loading conditions on the support attachment 
points and initiate a crack. EASA also states that a crack could lead 
to structural failure of the support, detachment of the damper unit, 
possible blocking of the yaw flight control channel, and reduced 
control of the helicopter. EASA AD No. 2014-0080 requires repetitive 
inspections of the support and, if there is a crack, replacing the 
support.

FAA's Determination

    These helicopters have been approved by the aviation authority of 
France and are approved for operation in the United States. Pursuant to 
our bilateral agreement with France, EASA, its technical 
representative, has notified us of the unsafe condition described in 
the EASA AD. We are issuing this AD because we evaluated all 
information provided by EASA and determined the unsafe condition exists 
and is likely to exist or develop on other helicopters of the same type 
design.

Related Service Information

    We reviewed Airbus Helicopters Alert Service Bulletin No. AS332-
05.00.98, Revision 0, dated March 26, 2014 (ASB), for Model AS332L2 
helicopters. This ASB describes procedures for inspecting the support 
attachment points for a crack and, if there is a crack, requires 
replacing the support.

AD Requirements

    This AD requires, for helicopters with 3,900 or more hours time-in-
service (TIS), within 100 hours TIS and at intervals not exceeding 825 
hours TIS, repetitively inspecting each support, P/N 332-A25-1334-00, 
at its attachment points for a crack. If there is a crack, this AD 
requires replacing the support before further flight.

Interim Action

    We consider this AD to be an interim action. If final action is 
later identified, we might consider further rulemaking then.

Costs of Compliance

    There are no costs of compliance with this AD because there are no 
helicopters with this type certificate on the U.S. Registry.

FAA's Justification and Determination of the Effective Date

    There are no helicopters with this type certificate on the U.S. 
Registry. Therefore, we believe it is unlikely that we will receive any 
adverse comments or useful information about this AD from U.S. 
Operators.
    Since an unsafe condition exists that requires the immediate 
adoption of this AD, we determined that notice and opportunity for 
public comment before issuing this AD are unnecessary because there are 
none of these products on the U.S. Registry.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed, I certify that this AD:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979);
    3. Will not affect intrastate aviation in Alaska to the extent that 
it justifies making a regulatory distinction; and
    4. Will not have a significant economic impact, positive or 
negative,

[[Page 63811]]

on a substantial number of small entities under the criteria of the 
Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

     Authority:  49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new airworthiness 
directive (AD):

2014-21-03 Airbus Helicopters (Previously Eurocopter France): 
Amendment 39-17995; Docket No. FAA-2014-0832; Directorate Identifier 
2014-SW-044-AD.

(a) Applicability

    This AD applies to Airbus Helicopters Model AS332L2 helicopters 
with a yaw control damper support (support) part number 332A25-1334-
00 installed, certificated in any category.

(b) Unsafe Condition

    This AD defines the unsafe condition as a crack on a support at 
an attachment point, which could result in failure of the support, 
separation of the yaw damper unit, blocking of the yaw flight 
control channel, and reduced control of the helicopter.

(c) Effective Date

    This AD becomes effective November 12, 2014.

(d) Compliance

    You are responsible for performing each action required by this 
AD within the specified compliance time unless it has already been 
accomplished prior to that time.

(e) Required Actions

    For helicopters with 3,900 hours time-in-service (TIS) or more, 
within 100 hours TIS and thereafter at intervals not exceeding 825 
hours TIS, using a light source and a mirror, inspect each support 
at the four attachment points for a crack. If there is a crack, 
before further flight, replace the support.

(f) Special Flight Permits

    Special flight permits are prohibited.

(g) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, Safety Management Group, FAA, may approve AMOCs 
for this AD. Send your proposal to: Rao Edupuganti, Aviation Safety 
Engineer, Regulations and Policy Group, Rotorcraft Directorate, FAA, 
2601 Meacham Blvd., Fort Worth, Texas 76137; telephone (817) 222-
5110; email rao.edupuganti@faa.gov.
    (2) For operations conducted under a 14 CFR part 119 operating 
certificate or under 14 CFR part 91, subpart K, we suggest that you 
notify your principal inspector, or lacking a principal inspector, 
the manager of the local flight standards district office or 
certificate holding district office, before operating any aircraft 
complying with this AD through an AMOC.

(h) Additional Information

    (1) Airbus Helicopters Alert Service Bulletin No. AS332-
05.00.98, Revision 0, dated March 26, 2014, which is not 
incorporated by reference, contains additional information about the 
subject of this AD. For service information identified in this AD, 
contact Airbus Helicopters, Inc., 2701 N. Forum Drive, Grand 
Prairie, TX 75052; telephone (972) 641-0000 or (800) 232-0323; fax 
(972) 641-3775; or at http://www.airbushelicopters.com/techpub. You 
may review a copy of the service information at the FAA, Office of 
the Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room 
663, Fort Worth, Texas 76137.
    (2) The subject of this AD is addressed in European Aviation 
Safety Agency (EASA) AD No. 2014-0080, dated March 27, 2014. You may 
view the EASA AD on the Internet at http://www.regulations.gov in 
Docket No. FAA-2014-0832.

(i) Subject

    Joint Aircraft Service Component (JASC) Code: 6700: Rotorcraft 
Flight Control.


    Issued in Fort Worth, Texas, on October 6, 2014.
Lance T. Gant,
Acting Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. 2014-25406 Filed 10-24-14; 8:45 am]
BILLING CODE 4910-13-P


