
[Federal Register Volume 79, Number 178 (Monday, September 15, 2014)]
[Rules and Regulations]
[Pages 54893-54895]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 2014-21880]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2014-0216; Directorate Identifier 2013-SW-045-AD; 
Amendment 39-17964; AD 2014-07-04R1]
RIN 2120-AA64


Airworthiness Directives; Sikorsky Aircraft Corporation 
(Sikorsky) Helicopters

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: The FAA is revising airworthiness directive (AD) 2014-07-04 
that published in the Federal Register to correct certain errors. AD 
2014-07-04 applied to certain Sikorsky Model S-92A helicopters. The 
range of serial numbers in the Applicability section and a reference to 
the service information in the Required Actions section of the 
regulatory text are incorrect. This document corrects those errors. In 
all other respects, the original document remains the same.

DATES: This final rule is effective September 30, 2014.
    The Director of the Federal Register approved the incorporation by 
reference of a certain document listed in this AD as of May 1, 2014 (79 
FR 21385, April 16, 2014).
    We must receive comments on this AD by November 14, 2014.

ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains this AD, the regulatory evaluation, 
any comments received, and other information. The address for the 
Docket Office (phone: 800-647-5527) is

[[Page 54894]]

Document Management Facility, U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE., Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT: Caspar Wang, Aviation Safety Engineer, 
Boston Aircraft Certification Office, Engine & Propeller Directorate, 
FAA, 12 New England Executive Park, Burlington, Massachusetts 01803; 
telephone (781) 238-7799; email caspar.wang@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

    This AD is a final rule that involves requirements affecting flight 
safety, and we did not provide you with notice and an opportunity to 
provide your comments prior to it becoming effective. However, we 
invite you to participate in this rulemaking by submitting written 
comments, data, or views. We also invite comments relating to the 
economic, environmental, energy, or federalism impacts that resulted 
from adopting this AD. The most helpful comments reference a specific 
portion of the AD, explain the reason for any recommended change, and 
include supporting data. To ensure the docket does not contain 
duplicate comments, commenters should send only one copy of written 
comments, or if comments are filed electronically, commenters should 
submit them only one time. We will file in the docket all comments that 
we receive, as well as a report summarizing each substantive public 
contact with FAA personnel concerning this rulemaking during the 
comment period. We will consider all the comments we receive and may 
conduct additional rulemaking based on those comments.

Discussion

    AD 2014-07-04, Amendment 39-17818 (79 FR 21385, April 16, 2014), 
applied to certain Sikorsky Model S-92A helicopters and required, in 
part, repetitively inspecting each clamp for correct installation. Due 
to typographical errors when the AD was published, an incorrect serial 
number and an incorrect reference to the service information appeared 
in the text of the rule.
    Specifically, AD 2014-07-04 included the following under paragraph 
(a) in the Applicability section: ``This AD applies to Model S-92A 
helicopters, serial numbers 92006 through 920084, certificated in any 
category.'' As published, the reference to serial number ``92006'' is 
incorrect and should be serial number ``920006.''
    AD 2014-07-04 also included the following under paragraph (e)(2) in 
the Required Actions section: ``(2) Within 5 hours TIS, inspect each 
clamp for correct installation as shown in Figures 1 through 14 of 
Sikorsky Aircraft Corporation Alert Service Bulletin No. 92-20-001, 
dated October 27, 2005 (ASB). If clamps are incorrectly installed or 
missing, before further flight, install clamps by following the 
Accomplishment Instructions, paragraphs 3.A.(4) through 3.A.(17) of the 
ASB.'' As published, the reference to ``Figures 1 through 14'' is 
incorrect because there are only 13 figures in the service information.
    The FAA has determined that it is appropriate to take action to 
revise AD 2014-07-04 to correct the serial numbers and figure 
reference. This revision ensures that this AD only applies to those 
aircraft subject to the unsafe condition and that it is possible for 
operators to comply with the AD by referencing the correct portions of 
the service information.
    No other part of the preamble or regulatory information has been 
changed. The final rule is being reprinted in its entirety for the 
convenience of affected operators.

Impact of the Correction

    Since this action reduces the number of helicopters to which the AD 
is applicable and corrects an obvious error in referencing the service 
information, it has no adverse economic impact and imposes no 
additional burden on any person. Therefore, we find that notice and 
opportunity for prior public comment are unnecessary and that good 
cause exists for making this amendment effective in less than 30 days.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
Reference, Safety.

Adoption of the Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by removing Airworthiness Directive (AD) 
2014-07-04, Amendment 39-17818 (79 FR 21385, April 16, 2014), and by 
adding the following new AD:

2014-07-04R1 Sikorsky Aircraft Corporation: Amendment 39-17964; 
Docket No. FAA-2014-0216; Directorate Identifier 2013-SW-045-AD.

 (a) Applicability

    This AD applies to Model S-92A helicopters, serial numbers 
920006 through 920084, certificated in any category.

(b) Unsafe Condition

    This AD defines the unsafe condition as an incorrectly installed 
clamp that does not provide adequate clearance to prevent chafing 
between the high voltage electrical lines and the hydraulic hoses. 
This condition could result in a fire in an area of the helicopter 
without extinguishing capability and subsequent loss of control of 
the helicopter.

(c) Affected ADs

    This AD revises AD 2014-07-04, Amendment 39-17818 (79 FR 21385, 
April 16, 2014).

(d) Effective Date

    This AD becomes effective September 30, 2014.

(e) Compliance

    You are responsible for performing each action required by this 
AD within the specified compliance time unless it has already been 
accomplished prior to that time.

(f) Required Actions

    (1) Within 5 hours time-in-service, inspect the electrical wires 
and the hydraulic lines in the upper deck of the helicopter for 
chafing between electrical wires and hydraulic lines. If there is 
chafing between electrical wires and hydraulic lines, before further 
flight, replace the unairworthy wires or lines with airworthy wires 
or lines.
    (2) Within 5 hours TIS, inspect each clamp for correct 
installation as shown in Figures 1 through 13 of Sikorsky Aircraft 
Corporation Alert Service Bulletin No. 92-20-001, dated October 27, 
2005 (ASB). If clamps are incorrectly installed or missing, before 
further flight, install clamps by following the Accomplishment 
Instructions, paragraph 3.A.(4) through 3.A.(17) of the ASB.
    (3) After each maintenance that requires removing clamps, comply 
with paragraphs (f)(1) and (f)(2) of this AD.

(g) Alternative Methods of Compliance (AMOCs)

    (1) The Manager, Boston Aircraft Certification Office, FAA, may 
approve AMOCs for this AD. Send your proposal to: Caspar Wang, 
Aviation Safety Engineer, Boston Aircraft Certification Office, 
Engine & Propeller Directorate, FAA, 12 New England Executive Park, 
Burlington, Massachusetts 01803; telephone (781) 238-7799; email 
caspar.wang@faa.gov.
    (2) For operations conducted under a 14 CFR part 119 operating 
certificate or under 14 CFR part 91, subpart K, we suggest that you 
notify your principal inspector, or lacking a principal inspector, 
the manager of

[[Page 54895]]

the local flight standards district office or certificate holding 
district office before operating any aircraft complying with this AD 
through an AMOC.

(h) Subject

    Joint Aircraft Service Component (JASC) Code: 2910 Main 
Hydraulic System.

(i) Material Incorporated by Reference

    (1) The Director of the Federal Register approved the 
incorporation by reference of the service information listed in this 
paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
    (2) You must use this service information as applicable to do 
the actions required by this AD, unless the AD specifies otherwise.
    (3) The following service information was approved for IBR on 
May 1, 2014 (79 FR 21385, April 16, 2014).
    (i) Sikorsky Aircraft Corporation Alert Service Bulletin No. 92-
20-001, dated October 27, 2005.
    (ii) Reserved.
    (4) For Sikorsky Aircraft Corporation service information 
identified in this AD, contact Customer Service Engineering, 124 
Quarry Road, Trumbull, CT 06611; telephone 1-800-Winged-S or 203-
416-4299; email sikorskywcs@sikorsky.com.
    (5) You may view this service information at FAA, Office of the 
Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, 
Fort Worth, Texas 76137. For information on the availability of this 
material at the FAA, call (817) 222-5110.
    (6) You may view this service information that is incorporated 
by reference at the National Archives and Records Administration 
(NARA). For information on the availability of this material at 
NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

    Issued in Fort Worth, Texas, on August 21, 2014.
Lance T. Gant,
Acting Directorate Manager, Rotorcraft Directorate, Aircraft 
Certification Service.
[FR Doc. 2014-21880 Filed 9-12-14; 8:45 am]
BILLING CODE 4910-13-P


