
[Federal Register: October 21, 2010 (Volume 75, Number 203)]
[Notices]               
[Page 65051]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr21oc10-94]                         

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

 
Consensus Standards, Standard Practice for Inspection of Airplane 
Electrical Wiring Systems

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of availability; request for comments.

-----------------------------------------------------------------------

SUMMARY: This notice announces the availability of consensus standards 
and the Federal Aviation Administration (FAA) intention to accept the 
ASTM International's F2696-08 Standard Practice for Inspection of 
Airplane Electrical Wiring Systems (Standard Practice) as an acceptable 
means of compliance to 14 CFR part 23 sections concerning electrical 
wiring systems. By this notice, the FAA finds the standards to be 
acceptable methods and procedures for inspection of electrical wiring 
systems for normal, utility, acrobatic, and commuter category 
airplanes.

DATES: Comments must be received on or before November 22, 2010.

ADDRESSES: Comments may be mailed to: Federal Aviation Administration, 
Small Airplane Directorate, Continued Operational Safety, ACE-111, 
Attention: James Brady, Room 301, 901 Locust, Kansas City, Missouri 
64106, or by e-mail to: james.brady@faa.gov. All comments must be 
marked: Consensus Standards Comments, and must specify the standard 
being addressed by ASTM F2696-08 Standard Practice for Inspection of 
Airplane Electrical Wiring Systems.

FOR FURTHER INFORMATION CONTACT: James Brady, Aerospace Engineer, 
Regulations and Policy Branch (ACE-111), Small Airplane Directorate, 
Aircraft Certification Service, Federal Aviation Administration, 901 
Locust, Room 301, Kansas City, Missouri 64106; telephone (816) 329-
4132; e-mail: james.brady@faa.gov.

SUPPLEMENTARY INFORMATION: This notice announces the availability of 
consensus standards. The FAA expects a suitable consensus standard to 
be reviewed at least every two years. The two-year review cycle will 
result in a standard revision or reapproval. A standard is issued under 
a fixed designation (i.e., F2696-08); the number immediately following 
the designation indicates the year of original adoption or, in the case 
of revision, the year of last revision. A number in parentheses 
indicates the year of last reapproval. A reapproval indicates a two-
year review cycle completed with no technical changes. A superscript 
epsilon ([egr]) indicates an editorial change since the last revision 
or reapproval. A notice of availability (NOA) will only be issued for 
new or revised standards. Reapproved standards issued with no technical 
changes or standards issued with editorial changes only (i.e., 
superscript epsilon ([egr])) are considered accepted by the FAA without 
need for an NOA.
    Comments Invited: Interested persons are invited to submit such 
written data, views, or arguments, as they may desire. Communications 
should identify the consensus standard number and be submitted to the 
address specified above. All communications received on or before the 
closing date for comments will be forwarded to ASTM International 
Committee F39 for consideration. The standard may be changed in light 
of the comments received. The FAA will address all comments received 
during the recurring review of the consensus standard and will 
participate in the consensus standard revision process.
    Background: Under the provisions of the revised Office of 
Management and Budget (OMB) Circular A-119, ``Federal Participation in 
the Development and Use of Voluntary Consensus Standards and in 
Conformity Assessment Activities,'' dated February 10, 1998, industry 
and the FAA have been working with ASTM International to develop 
consensus standards for the design, fabrication, modification, 
inspection, and maintenance of electrical systems installed on normal 
and utility category airplanes.
    These consensus standards satisfy the FAA's goal for airworthiness 
certification and a verifiable minimum safety level for normal, 
utility, acrobatic, and commuter category airplanes. Instead of 
developing airworthiness standards through the rulemaking process, the 
FAA participates as a member of Committee F39 in developing these 
standards. The use of the consensus standard process assures government 
and industry discussion and agreement on appropriate standards for the 
required level of safety.

Consensus Standards in This Notice of Availability

    The FAA has reviewed the standards presented in this NOA for 
compliance with the regulatory requirements of the rule. Any normal, 
utility, acrobatic, and commuter aircraft issued an airworthiness 
certificate, which has been designed, manufactured, operated, and 
maintained, in accordance with this and previously accepted ASTM 
consensus standards provides the public with the appropriate level of 
safety established under the regulations. The FAA maintains a listing 
of all accepted standards on the FAA Web site.
    The FAA finds the following new consensus standards acceptable for 
inspection of the specified aircraft. The consensus standard listed 
below may be used unless the FAA publishes a specific notification 
otherwise.
    ASTM Designation F2696-08, titled: Standard Practice for Inspection 
of Airplane Electrical Wiring Systems.

Availability

    These consensus standards are copyrighted by ASTM International, 
100 Barr Harbor Drive, Post Office Box C700, West Conshohocken, PA 
19428-2959. Individual reprints of this standard (single or multiple 
copies, or special compilations and other related technical 
information) may be obtained by contacting ASTM at this address, or at 
(610) 832-9585 (phone), (610) 832-9555 (fax), through service@astm.org 
(e-mail), or through the ASTM Web site at http://www.astm.org. To 
inquire about standard content and/or membership or about ASTM 
International Offices abroad, contact Daniel Schultz, Staff Manager for 
Committee F39 on Normal and Utility Category Airplane Electrical Wiring 
Systems: (610) 832-9716, dschultz@astm.org.

    Issued in Kansas City, Missouri, on October 13, 2010.
John Colomy,
Acting Manager, Small Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 2010-26537 Filed 10-20-10; 8:45 am]
BILLING CODE 4910-13-P

