
[Federal Register: May 20, 2009 (Volume 74, Number 96)]
[Rules and Regulations]               
[Page 23617-23618]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr20my09-4]                         

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2009-0035; Directorate Identifier 2008-NM-096-AD; 
Amendment 39-15909; AD 2009-10-13]
RIN 2120-AA64

 
Airworthiness Directives; Saab AB, Saab Aerosystems Model 340A 
(SAAB/SF340A) and SAAB 340B Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for the 
products listed above. This AD results from mandatory continuing 
airworthiness information (MCAI) originated by an aviation authority of 
another country to identify and correct an unsafe condition on an 
aviation product. The MCAI describes the unsafe condition as:

    Field experiences have revealed cracks in the frames and closing 
angle on the forward engine cowl door * * *.
    In case of a damaged frame and/or closing angle, the forward 
engine cowl door can loosen during flight and depart from the 
aircraft.

* * * * *
    We are issuing this AD to require actions to correct the unsafe 
condition on these products.

DATES: This AD becomes effective June 24, 2009.
    The Director of the Federal Register approved the incorporation by 
reference of a certain publication listed in this AD as of June 24, 
2009.

ADDRESSES: You may examine the AD docket on the Internet at http://
www.regulations.gov or in person at the U.S. Department of 
Transportation, Docket Operations, M-30, West Building Ground Floor, 
Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

FOR FURTHER INFORMATION CONTACT: Shahram Daneshmandi, Aerospace 
Engineer, International Branch, ANM-116, Transport Airplane 
Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; 
telephone (425) 227-1112; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR 
part 39 to include an AD that would apply to the specified products. 
That NPRM was published in the Federal Register on February 17, 2009 
(74 FR 7384). That NPRM proposed to correct an unsafe condition for the 
specified products. The MCAI states:

    Field experiences have revealed cracks in the frames and closing 
angle on the forward engine cowl door NS STA [nacelle station] 203 
and 250.
    In case of a damaged frame and/or closing angle, the forward 
engine cowl door can loosen during flight and depart from the 
aircraft.
    This AD is issued to require a detailed inspection to find out 
if there are any cracks [or deformations or wear damage] in the 
frames and/or the closing angles. The inspection is on four points 
on each of the forward engine cowl doors.

The corrective action depends on if the crack, deformation, or wear 
damage is within or outside certain defined limits, and includes doing 
a repair either in accordance with the specified service information, 
or contacting Saab for repair instructions and doing the repair. You 
may obtain further information by examining the MCAI in the AD docket.

Comments

    We gave the public the opportunity to participate in developing 
this AD. We received no comments on the NPRM or on the determination of 
the cost to the public.

Conclusion

    We reviewed the available data and determined that air safety and 
the public interest require adopting the AD as proposed.

Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in 
general, agree with their substance. But we might have found it 
necessary to use different words from those in the MCAI to ensure the 
AD is clear for U.S. operators and is enforceable. In making these 
changes, we do not intend to differ substantively from the information 
provided in the MCAI and related service information.
    We might also have required different actions in this AD from those 
in the MCAI in order to follow our FAA policies. Any such differences 
are highlighted in a NOTE within the AD.

Costs of Compliance

    We estimate that this AD will affect 141 products of U.S. registry. 
We also estimate that it will take about 2 work-hours per product to 
comply with the basic requirements of this AD. The average labor rate 
is $80 per work-hour. Based on these figures, we estimate the cost of 
this AD to the U.S. operators to be $22,560, or $160 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed above, I certify this AD:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979); and
    3. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities

[[Page 23618]]

under the criteria of the Regulatory Flexibility Act.
    We prepared a regulatory evaluation of the estimated costs to 
comply with this AD and placed it in the AD docket.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://
www.regulations.gov; or in person at the Docket Operations office 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains the NPRM, the regulatory evaluation, 
any comments received, and other information. The street address for 
the Docket Operations office (telephone (800) 647-5527) is in the 
ADDRESSES section. Comments will be available in the AD docket shortly 
after receipt.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, under the authority delegated to me by the Administrator, 
the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority:  49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new AD:

2009-10-13 Saab AB, Saab Aerosystems: Amendment 39-15909. Docket No. 
FAA-2009-0035; Directorate Identifier 2008-NM-096-AD.

Effective Date

    (a) This airworthiness directive (AD) becomes effective June 24, 
2009.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to Saab AB, Saab Aerosystems Model 340A 
(SAAB/SF340A) airplanes, serial numbers (S/Ns) 004 through 159 
inclusive, and Model SAAB 340B airplanes, S/Ns 160 through 459 
inclusive; certificated in any category.

Subject

    (d) Air Transport Association (ATA) of America Code 71: 
Powerplant.

Reason

    (e) The mandatory continuing airworthiness information (MCAI) 
states:
    Field experiences have revealed cracks in the frames and closing 
angle on the forward engine cowl door NS STA [nacelle station] 203 
and 250.
    In case of a damaged frame and/or closing angle, the forward 
engine cowl door can loosen during flight and depart from the 
aircraft.
    This AD is issued to require a detailed inspection to find out 
if there are any cracks [or deformations or wear damage] in the 
frames and/or the closing angles. The inspection is on four points 
on each of the forward engine cowl doors.

The corrective action depends on if the crack, deformation, or wear 
damage is within or outside certain defined limits, and includes 
doing a repair either in accordance with the specified service 
information, or contacting Saab for repair instructions and doing 
the repair.

Actions and Compliance

    (f) Unless already done, do the following actions.
    (1) Within 1,000 flight hours after the effective date of this 
AD, do a detailed inspection for cracking, deformation, or wear 
damage of the frame and closing angle on the forward engine cowl 
door, in accordance with the Accomplishment Instructions of Saab 
Service Bulletin 340-71-060, dated February 8, 2008.
    (2) If any crack, deformation, or wear damage is found during 
the inspection required by paragraph (f)(1) of this AD, before 
further flight, do all applicable corrective actions in accordance 
with the Accomplishment Instructions of Saab Service Bulletin 340-
71-060, dated February 8, 2008.
    (3) Submit a report of the findings of the inspection required 
by paragraph (f)(1) of this AD to Saab at the address specified in 
Saab Service Bulletin 340-71-060, dated February 8, 2008. Submit the 
report at the applicable time specified in paragraph (f)(3)(i) or 
(f)(3)(ii) of this AD. The report must include the information 
specified in the ``Inspection Result Formula'' form in the service 
bulletin.
    (i) If the inspection was done after the effective date of this 
AD: Submit the report within 30 days after the inspection.
    (ii) If the inspection was accomplished before the effective 
date of this AD: Submit the report within 30 days after the 
effective date of this AD.

FAA AD Differences

    Note 1: This AD differs from the MCAI and/or service information 
as follows: No differences.

Other FAA AD Provisions

    (g) The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, 
International Branch, ANM-116, Transport Airplane Directorate, FAA, 
has the authority to approve AMOCs for this AD, if requested using 
the procedures found in 14 CFR 39.19. Send information to ATTN: 
Shahram Daneshmandi, Aerospace Engineer, International Branch, ANM-
116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., 
Renton, Washington 98057-3356; telephone (425) 227-1112; fax (425) 
227-1149. Before using any approved AMOC on any airplane to which 
the AMOC applies, notify your appropriate principal inspector (PI) 
in the FAA Flight Standards District Office (FSDO), or lacking a PI, 
your local FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, under the provisions of the Paperwork Reduction Act, the 
Office of Management and Budget (OMB) has approved the information 
collection requirements and has assigned OMB Control Number 2120-
0056.

Related Information

    (h) Refer to MCAI European Aviation Safety Agency (EASA) 
Airworthiness Directive 2008-0069, dated April 11, 2008; and Saab 
Service Bulletin 340-71-060, dated February 8, 2008; for related 
information.

Material Incorporated by Reference

    (i) You must use Saab Service Bulletin 340-71-060, dated 
February 8, 2008, to do the actions required by this AD, unless the 
AD specifies otherwise.
    (1) The Director of the Federal Register approved the 
incorporation by reference of this service information under 5 
U.S.C. 552(a) and 1 CFR part 51.
    (2) For service information identified in this AD, contact Saab 
Aircraft AB, SAAB Aerosystems, SE-581 88, Link[ouml]ping, Sweden; 
telephone +46 13 18 5591; fax +46 13 18 4874; e-mail 
saab2000.techsupport@saabgroup.com; Internet http://
www.saabgroup.com.
    (3) You may review copies of the service information at the FAA, 
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington. For information on the availability of this material at 
the FAA, call 425-227-1221 or 425-227-1152.
    (4) You may also review copies of the service information that 
is incorporated by reference at the National Archives and Records 
Administration (NARA). For information on the availability of this 
material at NARA, call 202-741-6030, or go to: http://
www.archives.gov/federal_register/code_of_federal_regulations/
ibr_locations.html.

    Issued in Renton, Washington, on May 6, 2009.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. E9-11279 Filed 5-19-09; 8:45 am]

BILLING CODE 4910-13-P
