
[Federal Register: August 4, 2008 (Volume 73, Number 150)]
[Proposed Rules]               
[Page 45174-45176]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr04au08-9]                         

=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2008-0832; Directorate Identifier 2008-NM-067-AD]
RIN 2120-AA64

 
Airworthiness Directives; Airbus Model A318, A319, A320, and A321 
Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: We propose to adopt a new airworthiness directive (AD) for the 
products listed above. This proposed AD results from mandatory 
continuing airworthiness information (MCAI) originated by an aviation 
authority of another country to identify and correct an unsafe 
condition on an aviation product. The MCAI describes the unsafe 
condition as:

    In-service experience has shown that a fracture of the gerotor 
pump of the A320 RAT [ram air turbine] may occur. This may lead to 
the non-operation of the RAT in case of an in-flight deployment.
    The Non-Deployment or Non-Pressurization of the RAT, associated 
with a double engine failure or a total loss of normal electrical 
power generation constitutes an unsafe condition.
* * * * *
The proposed AD would require actions that are intended to address the 
unsafe condition described in the MCAI.

DATES: We must receive comments on this proposed AD by September 3, 
2008.

ADDRESSES: You may send comments by any of the following methods:
     Federal eRulemaking Portal: Go to http://
www.regulations.gov. Follow the instructions for submitting comments.
     Fax: (202) 493-2251.
     Mail: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue, SE., Washington, DC 20590.
     Hand Delivery: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-40, 1200 New 
Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday 
through Friday, except Federal holidays.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://
www.regulations.gov; or in person at the Docket Operations office 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains this proposed AD, the regulatory 
evaluation, any comments received, and other information. The street 
address for the Docket Operations office (telephone (800) 647-5527) is 
in the ADDRESSES section. Comments will be available in the AD docket 
shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Tim Dulin, Aerospace Engineer, 
International Branch, ANM-116, Transport Airplane Directorate, FAA, 
1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 
227-2141; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

    We invite you to send any written relevant data, views, or 
arguments about this proposed AD. Send your comments to an address 
listed under the ADDRESSES section. Include ``Docket No. FAA-2008-0832; 
Directorate Identifier 2008-NM-067-AD'' at the beginning of your 
comments. We specifically invite comments on the overall regulatory, 
economic, environmental, and energy aspects of this proposed AD. We 
will consider all comments received by the closing date and may amend 
this proposed AD based on those comments.
    We will post all comments we receive, without change, to http://
www.regulations.gov, including any personal information you provide. We 
will also post a report summarizing each substantive verbal contact we 
receive about this proposed AD.

Discussion

    The European Aviation Safety Agency (EASA), which is the Technical 
Agent for the Member States of the European Community, has issued EASA 
Airworthiness Directive 2008-0034, dated February 20, 2008 [corrected 
February 21, 2008] (referred to after this as ``the MCAI''), to correct 
an unsafe condition for the specified products. The MCAI states:

    In-service experience has shown that a fracture of the gerotor 
pump of the A320 RAT [ram air turbine] may occur. This may lead to 
the non-operation of the RAT in case of an in-flight deployment.
    The Non-Deployment or Non-Pressurization of the RAT, associated 
with a double engine failure or a total loss of normal electrical 
power generation constitutes an unsafe condition.
    This AD mandates the replacement of the affected gerotor pump 
assembly, which will provide the required improved reliability of 
the RAT.
    The implementation of this modification was originally managed 
by an AIRBUS monitoring campaign. However, the rate of installation 
of the modification by operators has not met the predicted target. 
As such and to ensure continued compliance with the certification 
requirements it is considered necessary to require compliance by use 
of [an] AD.
* * * * *
You may obtain further information by examining the MCAI in the AD 
docket.

Relevant Service Information

    Airbus has issued Service Bulletin A320-29-1122, dated July 27, 
2006. The actions described in this service information are intended to 
correct the unsafe condition identified in the MCAI.

FAA's Determination and Requirements of This Proposed AD

    This product has been approved by the aviation authority of another 
country, and is approved for operation in the United States. Pursuant 
to our bilateral agreement with the State of Design Authority, we have 
been notified of the unsafe condition described in the MCAI and service 
information referenced above. We are proposing this AD because we 
evaluated all pertinent information and determined an unsafe condition 
exists and is likely to exist or develop on other products of the same 
type design.

Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in 
general, agree with their substance. But we might have found it 
necessary to use different words from those in the MCAI to ensure the 
AD is clear for U.S. operators and is enforceable. In making these 
changes, we do not intend to differ substantively from the information 
provided in the MCAI and related service information.
    We might also have proposed different actions in this AD from those 
in the MCAI in order to follow FAA policies. Any such differences are

[[Page 45175]]

highlighted in a Note within the proposed AD.

Costs of Compliance

    Based on the service information, we estimate that this proposed AD 
would affect about 758 products of U.S. registry. We also estimate that 
it would take about 5 work-hours per product to comply with the basic 
requirements of this proposed AD. The average labor rate is $80 per 
work-hour. Required parts would cost about $0 per product. Where the 
service information lists required parts costs that are covered under 
warranty, we have assumed that there will be no charge for these costs. 
As we do not control warranty coverage for affected parties, some 
parties may incur costs higher than estimated here. Based on these 
figures, we estimate the cost of the proposed AD on U.S. operators to 
be $303,200, or $400 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this proposed AD would not have federalism 
implications under Executive Order 13132. This proposed AD would not 
have a substantial direct effect on the States, on the relationship 
between the national Government and the States, or on the distribution 
of power and responsibilities among the various levels of government.
    For the reasons discussed above, I certify this proposed 
regulation:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979); and
    3. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a regulatory evaluation of the estimated costs to 
comply with this proposed AD and placed it in the AD docket.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

    2. The FAA amends Sec.  39.13 by adding the following new AD:

Airbus: Docket No. FAA-2008-0832; Directorate Identifier 2008-NM-
067-AD.

Comments Due Date

    (a) We must receive comments by September 3, 2008.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to all Airbus Model A318, A319, A320, and 
A321 airplanes, certificated in any category; except airplanes on 
which AIRBUS Modification 27189 was done in production or AIRBUS 
Service Bulletin A320-29-1100 was done in service, and on which 
AIRBUS Modification 28413 was not done in production.

Subject

    (d) Air Transport Association (ATA) of America Code 29: 
Hydraulic power.

Reason

    (e) The mandatory continuing airworthiness information (MCAI) 
states:

    In-service experience has shown that a fracture of the gerotor 
pump of the A320 RAT [ram air turbine] may occur. This may lead to 
the non-operation of the RAT in case of an in-flight deployment.
    The Non-Deployment or Non-Pressurization of the RAT, associated 
with a double engine failure or a total loss of normal electrical 
power generation constitutes an unsafe condition.
    This AD mandates the replacement of the affected gerotor pump 
assembly, which will provide the required improved reliability of 
the RAT.
    The implementation of this modification was originally managed 
by an AIRBUS monitoring campaign. However, the rate of installation 
of the modification by operators has not met the predicted target. 
As such and to ensure continued compliance with the certification 
requirements it is considered necessary to require compliance by use 
of [an] AD.
* * * * *

Actions and Compliance

    (f) Unless already done, do the following actions.
    (1) Within 15 months after the effective date of this AD, 
identify the part number (P/N) and serial number (S/N) of the RAT in 
accordance with the Accomplishment Instructions of Airbus Service 
Bulletin A320-29-1122, dated July 27, 2006.
    (2) For airplanes on which a RAT with P/N 680203037 is installed 
that has a S/N between 0101 and 0354 inclusive: Before further 
flight, replace the gerotor pump assembly and re-identify the RAT in 
accordance with the service bulletin.
    (3) For airplanes on which a RAT with P/N 680203037 is installed 
that does not have a S/N between 0101 and 0354 inclusive, or a RAT 
with a P/N other than P/N 680203037 is installed: No further action 
is required by this AD.

FAA AD Differences

    Note: This AD differs from the MCAI and/or service information 
as follows: No differences.

Other FAA AD Provisions

    (g) The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, 
International Branch, FAA, has the authority to approve AMOCs for 
this AD, if requested using the procedures found in 14 CFR 39.19. 
Send information to ATTN: Tim Dulin, Aerospace Engineer, 
International Branch, ANM-116, Transport Airplane Directorate, FAA, 
1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone 
(425) 227-2141; fax (425) 227-1149. Before using any approved AMOC 
on any airplane to which the AMOC applies, notify your appropriate 
principal inspector (PI) in the FAA Flight Standards District Office 
(FSDO), or lacking a PI, your local FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, under the provisions of the Paperwork Reduction Act, the 
Office of Management and Budget (OMB) has approved the information 
collection requirements and has assigned OMB Control Number 2120-
0056.

Related Information

    (h) Refer to MCAI EASA Airworthiness Directive 2008-0034, dated 
February 20, 2008 [corrected February 21, 2008], and Airbus Service 
Bulletin A320-29-1122, dated July 27, 2006, for related information.


[[Page 45176]]


    Issued in Renton, Washington, on July 23, 2008.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
 [FR Doc. E8-17782 Filed 8-1-08; 8:45 am]

BILLING CODE 4910-13-P
