
[Federal Register: June 24, 2008 (Volume 73, Number 122)]
[Proposed Rules]               
[Page 35597-35598]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr24jn08-15]                         


[[Page 35597]]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2008-0668; Directorate Identifier 2008-NM-088-AD]
RIN 2120-AA64

 
Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. 
(EMBRAER) Model ERJ 190 Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: We propose to adopt a new airworthiness directive (AD) for the 
products listed above. This proposed AD results from mandatory 
continuing airworthiness information (MCAI) originated by an aviation 
authority of another country to identify and correct an unsafe 
condition on an aviation product. The MCAI describes the unsafe 
condition as:

    During aircraft structure fatigue tests, cracks were found in 
the wing lower skin stringers between ribs 7 and 10 on both wings. 
In order to prevent fatigue cracks in the wing lower skin stringers, 
which could result in fuel leakage and reduced structural integrity 
of the wing, the referred stringers must be reworked.

The proposed AD would require actions that are intended to address the 
unsafe condition described in the MCAI.

DATES: We must receive comments on this proposed AD by July 24, 2008.

ADDRESSES: You may send comments by any of the following methods:
     Federal eRulemaking Portal: Go to http://
www.regulations.gov. Follow the instructions for submitting comments.
     Fax: (202) 493-2251.
     Mail: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue, SE., Washington, DC 20590.
     Hand Delivery: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-40, 1200 New 
Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday 
through Friday, except Federal holidays.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://
www.regulations.gov; or in person at the Docket Operations office 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains this proposed AD, the regulatory 
evaluation, any comments received, and other information. The street 
address for the Docket Operations office (telephone (800) 647-5527) is 
in the ADDRESSES section. Comments will be available in the AD docket 
shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Kenny Kaulia, Aerospace Engineer, 
International Branch, ANM-116, Transport Airplane Directorate, FAA, 
1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 
227-2848; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

    We invite you to send any written relevant data, views, or 
arguments about this proposed AD. Send your comments to an address 
listed under the ADDRESSES section. Include ``Docket No. FAA-2008-0668; 
Directorate Identifier 2008-NM-088-AD'' at the beginning of your 
comments. We specifically invite comments on the overall regulatory, 
economic, environmental, and energy aspects of this proposed AD. We 
will consider all comments received by the closing date and may amend 
this proposed AD based on those comments.
    We will post all comments we receive, without change, to http://
www.regulations.gov, including any personal information you provide. We 
will also post a report summarizing each substantive verbal contact we 
receive about this proposed AD.

Discussion

    The Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC), 
which is the aviation authority for Brazil, has issued Brazilian 
Airworthiness Directive 2008-01-02, effective February 25, 2008 
(referred to after this as ``the MCAI''), to correct an unsafe 
condition for the specified products. The MCAI states:

    During aircraft structure fatigue tests, cracks were found in 
the wing lower skin stringers between ribs 7 and 10 on both wings. 
In order to prevent fatigue cracks in the wing lower skin stringers, 
which could result in fuel leakage and reduced structural integrity 
of the wing, the referred stringers must be reworked.

The corrective actions include spot-facing the lower wing stringers 
between ribs 7 and 10, doing a dye-penetrant inspection of the reworked 
stringers, shot-peening if no cracking is found, contacting ANAC if any 
crack is found, and repairing. You may obtain further information by 
examining the MCAI in the AD docket.

Relevant Service Information

    EMBRAER has issued Service Bulletin 190-57-0005, Revision 01, dated 
October 27, 2006. The actions described in this service information are 
intended to correct the unsafe condition identified in the MCAI.

FAA's Determination and Requirements of This Proposed AD

    This product has been approved by the aviation authority of another 
country, and is approved for operation in the United States. Pursuant 
to our bilateral agreement with the State of Design Authority, we have 
been notified of the unsafe condition described in the MCAI and service 
information referenced above. We are proposing this AD because we 
evaluated all pertinent information and determined an unsafe condition 
exists and is likely to exist or develop on other products of the same 
type design.

Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in 
general, agree with their substance. But we might have found it 
necessary to use different words from those in the MCAI to ensure the 
AD is clear for U.S. operators and is enforceable. In making these 
changes, we do not intend to differ substantively from the information 
provided in the MCAI and related service information.
    We might also have proposed different actions in this AD from those 
in the MCAI in order to follow FAA policies. Any such differences are 
highlighted in a Note within the proposed AD.

Costs of Compliance

    Based on the service information, we estimate that this proposed AD 
would affect about 18 products of U.S. registry. We also estimate that 
it would take about 110 work-hours per product to comply with the basic 
requirements of this proposed AD. The average labor rate is $80 per 
work-hour. Based on these figures, we estimate the cost of the proposed 
AD on U.S. operators to be $158,400, or $8,800 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with

[[Page 35598]]

promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this proposed AD would not have federalism 
implications under Executive Order 13132. This proposed AD would not 
have a substantial direct effect on the States, on the relationship 
between the national Government and the States, or on the distribution 
of power and responsibilities among the various levels of government.
    For the reasons discussed above, I certify this proposed 
regulation:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979); and
    3. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a regulatory evaluation of the estimated costs to 
comply with this proposed AD and placed it in the AD docket.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

    2. The FAA amends Sec.  39.13 by adding the following new AD:

Empresa Brasileira De Aeronautica S.A. (EMBRAER): Docket No. FAA-
2008-0668; Directorate Identifier 2008-NM-088-AD.

Comments Due Date

    (a) We must receive comments by July 24, 2008.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to EMBRAER Model ERJ 190-100 STD, -100 LR, -
100 IGW, -100ECJ, -200 STD, -200 LR, and -200 IGW airplanes, 
certificated in any category, serial numbers 19000004, 19000006 
through 19000028 inclusive, and 19000030 through 19000039 inclusive.

Subject

    (d) Air Transport Association (ATA) of America Code 57: Wings.

Reason

    (e) The mandatory continuing airworthiness information (MCAI) 
states:

    During aircraft structure fatigue tests, cracks were found in 
the wing lower skin stringers between ribs 7 and 10 on both wings. 
In order to prevent fatigue cracks in the wing lower skin stringers, 
which could result in fuel leakage and reduced structural integrity 
of the wing, the referred stringers must be reworked.

The corrective actions include spot-facing the lower wing stringers 
between ribs 7 and 10, doing a dye-penetrant inspection of the 
reworked stringers, shot-peening if no cracking is found, contacting 
Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) if any 
crack is found, and repairing.

Actions and Compliance

    (f) Unless already done: Prior to the accumulation of 5,000 
total flight cycles, or within 500 flight cycles after the effective 
date of this AD, whichever occurs later, do the following actions.
    (1) Spot-face the lower wing stringers between ribs 7 and 10 on 
both wings by changing their run out in accordance with the 
Accomplishment Instructions of EMBRAER Service Bulletin 190-57-0005, 
Revision 01, dated October 27, 2006.
    (2) Do a dye-penetrant inspection for cracking of the reworked 
stringers in accordance with the Accomplishment Instructions of 
EMBRAER Service Bulletin 190-57-0005, Revision 01, dated October 27, 
2006.
    (i) If no cracking is detected: Before further flight, shot-peen 
the stringer reworked area following the parameters indicated in the 
Accomplishment Instructions of EMBRAER Service Bulletin 190-57-0005, 
Revision 01, dated October 27, 2006.
    (ii) If any cracking is detected: Before further flight, contact 
the ANAC for repair instructions and repair.
    (3) Actions done before the effective date of this AD in 
accordance with EMBRAER Service Bulletin 190-57-0005, dated October 
10, 2006, are acceptable for compliance with the requirements of 
paragraph (f) of this AD.

FAA AD Differences

    Note: This AD differs from the MCAI and/or service information 
as follows: No differences.

Other FAA AD Provisions

    (g) The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, 
International Branch, ANM-116, Transport Airplane Directorate, FAA, 
has the authority to approve AMOCs for this AD, if requested using 
the procedures found in 14 CFR 39.19. Send information to ATTN: 
Kenny Kaulia, Aerospace Engineer, ANM-116, Transport Airplane 
Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-
3356; telephone (425) 227-2848; fax (425) 227-1149. Before using any 
approved AMOC on any airplane to which the AMOC applies, notify your 
appropriate principal inspector (PI) in the FAA Flight Standards 
District Office (FSDO), or lacking a PI, your local FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, under the provisions of the Paperwork Reduction Act, the 
Office of Management and Budget (OMB) has approved the information 
collection requirements and has assigned OMB Control Number 2120-
0056.

Related Information

    (h) Refer to MCAI Brazilian Airworthiness Directive 2008-01-02, 
effective February 25, 2008, and EMBRAER Service Bulletin 190-57-
0005, Revision 01, dated October 27, 2006, for related information.

    Issued in Renton, Washington, on June 9, 2008.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. E8-14187 Filed 6-23-08; 8:45 am]

BILLING CODE 4910-13-P
