
[Federal Register: April 28, 2008 (Volume 73, Number 82)]
[Rules and Regulations]               
[Page 22793-22795]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr28ap08-6]                         

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2008-0249; Directorate Identifier 2008-CE-012-AD; 
Amendment 39-15490; AD 2008-09-09]
RIN 2120-AA64

 
Airworthiness Directives; DORNIER LUFTFAHRT GmbH Models 228-200, 
228-201, 228-202, and 228-212 Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of 
Transportation (DOT).

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for the 
products listed above. This AD results from mandatory continuing 
airworthiness information (MCAI) issued by an aviation authority of 
another country to identify and correct an unsafe condition on an 
aviation product. The MCAI describes the unsafe condition as:

    During production testing of a batch of control cables, cracks 
inside the cable terminal were detected. Despite the specified 
strength at the date of delivery was achieved, it can not be 
excluded that the mechanical properties of the cable will degrade.

We are issuing this AD to require actions to correct the unsafe 
condition on these products.

DATES: This AD becomes effective June 2, 2008.
    On June 2, 2008, the Director of the Federal Register approved the 
incorporation by reference of certain publications listed in this AD.

ADDRESSES: You may examine the AD docket on the Internet at http://
www.regulations.gov or in person at Document Management Facility, U.S. 
Department of Transportation, Docket Operations, M-30, West Building 
Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 
20590.

FOR FURTHER INFORMATION CONTACT: Karl Schletzbaum, Aerospace Engineer, 
FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, 
Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090.

SUPPLEMENTARY INFORMATION: 

Discussion

    We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR 
part 39 to include an AD that would apply to the specified products. 
That NPRM was published in the Federal Register on March 5, 2008 (73 FR 
11841). That NPRM proposed to correct an unsafe condition for the 
specified products. The MCAI states:

    During production testing of a batch of control cables, cracks 
inside the cable terminal were detected. Despite the specified 
strength at the date of delivery was achieved, it can not be 
excluded that the mechanical properties of the cable will degrade.

The MCAI requires replacing rudder control cables, part number (P/N) B-
422420A00F delivered with European Aviation Safety Agency (EASA) Form 
One tracking number RS52074/05 after January 1, 2006 (also identified 
by production batch number 1141044, which is printed on the fork end 
next to the P/N), with FAA-approved serviceable rudder control cables. 
You

[[Page 22794]]

may obtain further information by examining the MCAI in the AD docket.

Comments

    We gave the public the opportunity to participate in developing 
this AD. We received no comments on the NPRM or on the determination of 
the cost to the public.

Conclusion

    We reviewed the available data and determined that air safety and 
the public interest require adopting the AD as proposed.

Differences Between This AD and the MCAI or Service Information

    We have reviewed the MCAI and related service information and, in 
general, agree with their substance. But we might have found it 
necessary to use different words from those in the MCAI to ensure the 
AD is clear for U.S. operators and is enforceable. In making these 
changes, we do not intend to differ substantively from the information 
provided in the MCAI and related service information.
    We might also have required different actions in this AD from those 
in the MCAI in order to follow FAA policies. Any such differences are 
highlighted in a NOTE within the AD.

Costs of Compliance

    We estimate that this AD will affect about 17 products of U.S. 
registry. We also estimate that it will take about 15 work-hours per 
product to comply with the basic requirements of this AD. The average 
labor rate is $80 per work-hour.
    Based on these figures, we estimate the cost of this AD on U.S. 
operators to be $20,400 or $1,200 per product.

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed above, I certify this AD:
    (1) Is not a ``significant regulatory action'' under Executive 
Order 12866;
    (2) Is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and
    (3) Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.
    We prepared a regulatory evaluation of the estimated costs to 
comply with this AD and placed it in the AD Docket.

Examining the AD Docket

    You may examine the AD docket on the Internet at http://
www.regulations.gov; or in person at the Docket Management Facility 
between 9 a.m. and 5 p.m., Monday through Friday, except Federal 
holidays. The AD docket contains the NPRM, the regulatory evaluation, 
any comments received, and other information. The street address for 
the Docket Office (telephone (800) 647-5527) is in the ADDRESSES 
section. Comments will be available in the AD docket shortly after 
receipt.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, under the authority delegated to me by the Administrator, 
the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new AD:

2008-09-09 DORNIER LUFTFAHRT GmbH: Amendment 39-15490; Docket No. 
FAA-2008-0249; Directorate Identifier 2008-CE-012-AD.

Effective Date

    (a) This airworthiness directive (AD) becomes effective June 2, 
2008.

Affected ADs

    (b) None.

Applicability

    (c) This AD applies to Models 228-200, 228-201, 228-202, and 
228-212, all serial numbers, that are:
    (1) Equipped with rudder control cables, part number (P/N) B-
422420A00F delivered with European Aviation Safety Agency (EASA) 
Form One tracking number RS52074/05 after January 1, 2006 (also 
identified by production batch number 1141044, which is printed on 
the fork end next to the P/N); and
    (2) Certificated in any category.

Subject

    (d) Air Transport Association of America (ATA) Code 27: Flight 
Controls.

Reason

    (e) The mandatory continuing airworthiness information (MCAI) 
states:
    During production testing of a batch of control cables, cracks 
inside the cable terminal were detected. Despite the specified 
strength at the date of delivery was achieved, it can not be 
excluded that the mechanical properties of the cable will degrade.

The MCAI AD requires replacing rudder control cables, P/N B-
422420A00F delivered with EASA Form One tracking number RS52074/05 
after January 1, 2006 (also identified by production batch number 
1141044, which is printed on the fork end next to the P/N), with 
FAA-approved serviceable rudder control cables.

Actions and Compliance

    (f) Unless already done, do the following actions:
    (1) Replace the rudder control cables identified in paragraph 
(c)(1) of this AD with FAA-approved serviceable rudder control 
cables following RUAG Aerospace Defence Technology Dornier 228 Alert 
Service Bulletin No. ASB-228-269, dated March 23, 2007, at whichever 
of the following occurs first:
    (i) Upon reaching 1,200 total hours time-in-service (TIS) on the 
rudder control cables identified in paragraph (c)(1) of this AD or 
within 30 days after June 2, 2008 (the effective date of this AD), 
whichever occurs later; or
    (ii) Within the next 3 months after June 2, 2008 (the effective 
date of this AD).
    (2) As of June 2, 2008 (the effective date of this AD), do not 
install any rudder control cables, P/N B-422420A00F delivered with 
EASA Form One tracking number RS52074/05 after January 1, 2006 (also 
identified by production batch number 1141044, which is printed on 
the fork end next to the P/N).
    (3) Within 30 days after doing the replacement required in 
paragraph (f)(1) of this AD, return the removed rudder control 
cables and any held as spares to the manufacturer at the address on 
RUAG Aerospace Defence Technology Dornier 228 Alert Service Bulletin 
No. ASB-228-269, dated March 23, 2007.

[[Page 22795]]

FAA AD Differences

    Note: This AD differs from the MCAI and/or service information 
as follows: No differences.

Other FAA AD Provisions

    (g) The following provisions also apply to this AD:
    (1) Alternative Methods of Compliance (AMOCs): The Manager, 
Standards Staff, FAA, has the authority to approve AMOCs for this 
AD, if requested using the procedures found in 14 CFR 39.19. Send 
information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, 
Small Airplane Directorate, 901 Locust, Room 301, Kansas City, 
Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090. 
Before using any approved AMOC on any airplane to which the AMOC 
applies, notify your appropriate principal inspector (PI) in the FAA 
Flight Standards District Office (FSDO), or lacking a PI, your local 
FSDO.
    (2) Airworthy Product: For any requirement in this AD to obtain 
corrective actions from a manufacturer or other source, use these 
actions if they are FAA-approved. Corrective actions are considered 
FAA-approved if they are approved by the State of Design Authority 
(or their delegated agent). You are required to assure the product 
is airworthy before it is returned to service.
    (3) Reporting Requirements: For any reporting requirement in 
this AD, under the provisions of the Paperwork Reduction Act (44 
U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has 
approved the information collection requirements and has assigned 
OMB Control Number 2120-0056.

Related Information

    (h) Refer to MCAI Luftfahrt-Bundesamt (LBA) AD No. D-2007-353, 
dated December 28, 2007, and RUAG Aerospace Defence Technology 
Dornier 228 Alert Service Bulletin No. ASB-228-269, dated March 23, 
2007, for related information.

Material Incorporated by Reference

    (i) You must use RUAG Aerospace Defence Technology Dornier 228 
Alert Service Bulletin No. ASB-228-269, dated March 23, 2007, to do 
the actions required by this AD, unless the AD specifies otherwise.
    (1) The Director of the Federal Register approved the 
incorporation by reference of this service information under 5 
U.S.C. 552(a) and 1 CFR part 51.
    (2) For service information identified in this AD, contact RUAG 
Aerospace Services, Customer Support, P.O. Box 1253, 82231 Wessling, 
Germany.
    (3) You may review copies at the FAA, Central Region, Office of 
the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 
64106; or at the National Archives and Records Administration 
(NARA). For information on the availability of this material at 
NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-
register/cfr/ibr-locations.html.

    Issued in Kansas City, Missouri, on April 18, 2008.
David R. Showers,
Acting Manager, Small Airplane Directorate, Aircraft Certification 
Service.
 [FR Doc. E8-9055 Filed 4-25-08; 8:45 am]

BILLING CODE 4910-13-P
