
[Federal Register: April 1, 2010 (Volume 75, Number 62)]
[Notices]               
[Page 16458-16459]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr01ap10-65]                         

-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

[EPA-HQ-OECA-2009-0402; FRL-9132-6]

 
Agency Information Collection Activities; Submission to OMB for 
Review and Approval; Comment Request; NESHAP for Plastic Parts and 
Products Surface Coating (Renewal), EPA ICR Number 2044.04, OMB Control 
Number 2060-0537

AGENCY: Environmental Protection Agency (EPA).

ACTION: Notice.

-----------------------------------------------------------------------

SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 
et seq.), this document announces that an Information Collection 
Request (ICR) has been forwarded to the Office of Management and Budget 
(OMB) for review and approval. This is a request to renew an existing 
approved collection. The ICR which is abstracted below describes the 
nature of the collection and the estimated burden and cost.

DATES: Additional comments may be submitted on or before May 3, 2010.

ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ-
OECA-2009-0402, to (1) EPA online using http://www.regulations.gov (our 
preferred method), or by e-mail to docket.oeca@epa.gov, or by mail to: 
EPA Docket Center (EPA/DC), Environmental Protection Agency, 
Enforcement and Compliance Docket and Information Center, mail code 
28221T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) 
OMB at:

[[Page 16459]]

Office of Information and Regulatory Affairs, Office of Management and 
Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., 
Washington, DC 20503.

FOR FURTHER INFORMATION CONTACT: Robert C. Marshall, Jr., Office of 
Compliance, Mail Code: 2223A, Environmental Protection Agency, 1200 
Pennsylvania Avenue, NW., Washington, DC 20460; telephone number: (202) 
564-7021; fax number: (202) 564-0050; e-mail address: 
marshall.robert@epa.gov.

SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB 
for review and approval according to the procedures prescribed in 5 CFR 
1320.12. On July 8, 2009 (74 FR 32580), EPA sought comments on this ICR 
pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional 
comments on this ICR should be submitted to EPA and OMB within 30 days 
of this notice.
    EPA has established a public docket for this ICR under docket ID 
number EPA-HQ-OECA-2009-0402, which is available for public viewing 
online at http://www.regulations.gov, in person viewing at the 
Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), 
EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The 
EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 
p.m., Monday through Friday, excluding legal holidays. The telephone 
number for the Reading Room is (202) 566-1744, and the telephone number 
for the Enforcement and Compliance Docket is (202) 566-1752.
    Use EPA's electronic docket and comment system at http://
www.regulations.gov, to submit or view public comments, access the 
index listing of the contents of the docket, and to access those 
documents in the docket that are available electronically. Once in the 
system, select ``docket search,'' then key in the docket ID number 
identified above. Please note that EPA's policy is that public 
comments, whether submitted electronically or in paper, will be made 
available for public viewing at http://www.regulations.gov, as EPA 
receives them and without change, unless the comment contains 
copyrighted material, Confidential Business Information (CBI), or other 
information whose public disclosure is restricted by statute. For 
further information about the electronic docket, go to http://
www.regulations.gov.
    Title: NESHAP for Plastic Parts and Products Surface Coating 
(Renewal).
    ICR Numbers: EPA ICR Number 2044.04, OMB Control Number 2060-0537.
    ICR Status: This ICR is scheduled to expire on April 30, 2010. 
Under OMB regulations, the Agency may continue to conduct or sponsor 
the collection of information while this submission is pending at OMB. 
An Agency may not conduct or sponsor, and a person is not required to 
respond to, a collection of information unless it displays a currently 
valid OMB control number. The OMB control numbers for EPA's regulations 
in title 40 of the CFR, after appearing in the Federal Register when 
approved, are listed in 40 CFR part 9, and displayed either by 
publication in the Federal Register or by other appropriate means, such 
as on the related collection instrument or form, if applicable. The 
display of OMB control numbers in certain EPA regulations is 
consolidated in 40 CFR part 9.
    Abstract: Entities potentially affected by this action are the 
owners or operators of plastic parts and products surface coating 
facilities. The affected entities are subject to the General Provisions 
of the NESHAP at 40 CFR part 63, subpart A, and any changes, or 
additions to the Provisions specified at 40 CFR part 63, subpart PPPP. 
Owners or operators of the affected facilities must submit a one-time-
only report of any physical or operational changes, initial performance 
tests, and periodic reports and results. Owners or operators are also 
required to maintain records of the occurrence and duration of any 
startup, shutdown, or malfunction in the operation of an affected 
facility, or any period during which the monitoring system is 
inoperative. Reports, at a minimum, are required semiannually.
    Burden Statement: The annual public reporting and recordkeeping 
burden for this collection of information is estimated to average 91 
hours per response. Burden means the total time, effort, or financial 
resources expended by persons to generate, maintain, retain, or 
disclose or provide information to or for a Federal agency. This 
includes the time needed to review instructions; develop, acquire, 
install, and utilize technology and systems for the purposes of 
collecting, validating, and verifying information, processing and 
maintaining information, and disclosing and providing information; 
adjust the existing ways to comply with any previously applicable 
instructions and requirements which have subsequently changed; train 
personnel to be able to respond to a collection of information; search 
data sources; complete and review the collection of information; and 
transmit or otherwise disclose the information.
    Respondents/Affected Entities: Plastic parts and products surface 
coating facilities.
    Estimated Number of Respondents: 828.
    Frequency of Response: Initially, occasionally, and semiannually.
    Estimated Total Annual Hour Burden: 320,917.
    Estimated Total Annual Cost: $27,444,633, which includes 
$27,180,233 in labor costs, $16,000 in capital/startup costs, and 
$248,400 in operation and maintenance (O&M) costs.
    Changes in the Estimates: There is a small decrease in the total 
estimated burden currently identified in the OMB Inventory of Approved 
ICR Burdens. This change in burden from the most recently approved ICR 
is due to an adjustment. Minor calculation errors in the previous ICR 
were corrected.

    Dated: March 22, 2010.
John Moses,
Director, Collection Strategies Division.
[FR Doc. 2010-7316 Filed 3-31-10; 8:45 am]
BILLING CODE 6560-50-P

