

[Federal Register: May 15, 2007 (Volume 72, Number 93)]
[Notices]               
[Page 27305-27306]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr15my07-38]                         

=======================================================================
-----------------------------------------------------------------------

ENVIRONMENTAL PROTECTION AGENCY

[EPA-HQ-OECA-2006-0738; FRL-8314-5]

 
Agency Information Collection Activities; Submission to OMB for 
Review and Approval; Comment Request; NESHAP for Metal Can 
Manufacturing Surface Coating (Renewal); EPA ICR Number 2079.03; OMB 
Control Number 2060-0541

AGENCY: Environmental Protection Agency (EPA).

ACTION: Notice.

-----------------------------------------------------------------------

SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 
et seq.), this document announces that an Information Collection 
Request (ICR) has been forwarded to the Office of Management and Budget 
(OMB) for review and approval. This is a request to renew an existing 
approved collection. The ICR which is abstracted below describes the 
nature of the collection and the estimated burden and cost.

DATES: Additional comments may be submitted on or before June 14, 2007.

ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ-
OECA-2006-0738, to (1) EPA online using http://www.regulations.gov (our preferred method), or by e-mail to docket.oeca@epa.gov, or by mail to: 

EPA Docket Center (EPA/DC), Environmental Protection Agency, 
Enforcement and Compliance Docket and Information Center, mail code 
2201T , 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) 
OMB at: Office of Information and Regulatory Affairs, Office of 
Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th 
Street, NW., Washington, DC 20503.

FOR FURTHER INFORMATION CONTACT: Leonard Lazarus, Compliance Assessment 
and Media Programs Division (CAMPD), Office of Compliance, (2223A), 
Environmental Protection Agency, 1200 Pennsylvania Avenue, NW., 
Washington, DC 20460; telephone number: (202) 564-6369; fax number: 
(202) 564-0050; e-mail address: lazarus.leonard@epa.gov.

SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB 
for review and approval according to the procedures prescribed in 5 CFR 
1320.12. On October 5, 2006 (71 FR 58853), EPA sought comments on this 
ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any 
additional comments on this ICR should be submitted to EPA and OMB 
within 30 days of this notice.
    EPA has established a public docket for this ICR under docket ID 
number EPA-HQ-OECA-2006-0738, which is available for public viewing 
online at http://www.regulations.gov, in person viewing at the 

Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), 
EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The 
EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 
p.m., Monday through Friday, excluding legal holidays. The telephone 
number for the Reading Room is (202) 566-1744, and the telephone number 
for the Enforcement and Compliance Docket is (202) 566-1752.
    Use EPA's electronic docket and comment system at http://www.regulations.gov
, to submit or view public comments, access the 

index listing of the contents of the docket, and to access those 
documents in the docket that are available electronically. Once in the 
system, select ``docket search,'' then key in the docket ID number 
identified above. Please note that EPA's policy is that public 
comments, whether submitted electronically or in paper, will be made 
available for public viewing at http://www.regulations.gov, as EPA 

receives them and without change, unless the comment contains 
copyrighted material, CBI, or other information whose public disclosure 
is restricted by statute. For further information about the electronic 
docket, go to http://www.regulations.gov.

    Title: NESHAP for Metal Can Manufacturing Surface Coating 
(Renewal).
    ICR Numbers: EPA ICR Number 2079.03; OMB Control Number 2060-0541.
    ICR Status: This ICR is scheduled to expire on June 30, 2007. Under 
OMB regulations, the Agency may continue to conduct or sponsor the 
collection of information while this submission is

[[Page 27306]]

pending at OMB. An Agency may not conduct or sponsor, and a person is 
not required to respond to, a collection of information unless it 
displays a currently valid OMB control number. The OMB control numbers 
for EPA's regulations in title 40 of the CFR, after appearing in the 
Federal Register when approved, are listed in 40 CFR part 9, and 
displayed either by publication in the Federal Register or by other 
appropriate means, such as on the related collection instrument or 
form, if applicable. The display of OMB control numbers in certain EPA 
regulations is consolidated in 40 CFR part 9.
    Abstract: Respondents are owners or operators of metal can 
manufacturing surface coating operations. Owners or operators of the 
affected facilities described must make initial reports when a source 
becomes subject to the standard, conduct and report on a performance 
test, demonstrate and report on continuous monitor performance, and 
maintain records of the occurrence and duration of any startup, 
shutdown, or malfunction in the operation of an affected facility. 
Semiannual reports of excess emissions are required. These 
notifications, reports, and records are essential in determining 
compliance; and are required, in general, of all sources subject to 
National Emission Standards for Hazardous Air Pollutants (NESHAP). Any 
owner or operator subject to the provisions of this part shall maintain 
a file of these measurements, and retain the file for at least five 
years following the date of such measurements, maintenance reports, and 
records. All reports are sent to the delegated state or local 
authority. In the event that there is no such delegated authority, the 
reports are sent directly to the EPA regional office.
    Burden Statement: The annual public reporting and recordkeeping 
burden for this collection of information is estimated to average 91 
hours per response. Burden means the total time, effort, or financial 
resources expended by persons to generate, maintain, retain, or 
disclose or provide information to or for a Federal agency. This 
includes the time needed to review instructions; develop, acquire, 
install, and utilize technology and systems for the purposes of 
collecting, validating, and verifying information, processing and 
maintaining information, and disclosing and providing information; 
adjust the existing ways to comply with any previously applicable 
instructions and requirements which have subsequently changed; train 
personnel to be able to respond to a collection of information; search 
data sources; complete and review the collection of information; and 
transmit or otherwise disclose the information.
    Respondents/Affected Entities: Owners or operators of metal can 
manufacturing surface coating operations.
    Estimated Number of Respondents: 71.
    Frequency of Response: Initially, Semiannually, On Occasion.
    Estimated Total Annual Hour Burden: 27,517.
    Estimated Total Annual Cost: $2,522,768, which comprises no 
annualized capital costs, $85,200 O&M costs and $2,438,568 in labor 
costs.
    Changes in the Estimates: The number of respondents has decreased 
from the most recently approved ICR due to an improved estimate of the 
number of facilities subject to 40 CFR part 63, subpart KKKK. Despite 
this decrease, the number of total annual responses has increased 
slightly due to a revised estimate that considers the semiannual report 
and excess emissions report separately, whereas the previous ICR 
grouped them as one report. There is an increase of 19,702 hours in the 
total estimated burden currently identified in the OMB Inventory of 
Approved ICR Burdens. The previous ICR included only the burden 
incurred by facilities initiating activities related to compliance in 
advance of the compliance date. The increase in burden is due to 
routine actions taken by the facilities to comply with 40 CFR part 63, 
subpart KKKK on an ongoing basis.
    The previous ICR shows higher capital/startup and O&M costs than 
this ICR due to installation of monitoring equipment so that the only 
costs incurred are those associated with O&M of the monitoring 
equipment. At this point in time, all of the subject facilities have 
installed the required monitoring equipment.

    Dated: May 7, 2007.
Sara Hisel-McCoy,
Acting Director, Collection Strategies Division.
[FR Doc. E7-9288 Filed 5-14-07; 8:45 am]

BILLING CODE 6560-50-P
